Good. I tape the mike between the tips under the plate. I use a piece of foam that's about 3" in diameter over the mike. Also you will have to get an extension cord for the mike. I got one from Staples.

yea i figured a 3.5mm is just an aux cord i can find anywhere.

i see a couple little fuzzy wind protectors for sale on amazon as well

those are great for higher speeds but I dont think would be necessary for 0-90.

here is an example Mosquito Ridge Run - YouTube

Also make sure you use the open back that comes with the gopro

most likely will be hitting above 90. especially if i use during any 1/4 mile runs etc....

thanks again for the info.

I made my own with some packing foam from work. :D I get wind noise as slow as about 20 mph. I modded a waterproof housing so that I can plug in the mike adapter. Used a dremel to cut a hole in the side of the housing. After I did this. Gopro came out with a housing with the holes already cut out.

decent deal for the whole setup. and stuff from HK doesnt take too long to get here

Skeleton Housing Case w Open Side Wire Connectable Mic for GoPro Hero 3 Blue | eBay

wait $20 for the case + mic? is this correct? lol

may be buying this now :yum:

and it's blue to match the Z?!?

Carbon Fiber mount
 

Just thought I would share the carbon fiber mount I made. Not sure if anyone has made one like this or not. I got my idea from looking at another forum DIY headrest camera mount: Build thread / How to.. - page 1 - Random Chat - MK5 Golf GTI

First here are some pics of the mount:

Attachment 111112

Attachment 111113


I got the various parts needed from home depot, ebay and amazon.

You will need:

1 x Carbon fiber rod : Amazon.com: ARRIS 3K Roll Wrapped 100% Pure Carbon Fiber Tube 23mm*25mm*500mm(2PCS) Glossy Surface: Toys & Games

1x GoPro bar mount:Amazon.com : Oumers Bike Handlebar Mount Motorcycle Seatpost Pole Mount Bicycle Mount Roll Bar Mount with Long Screw for Gopro HD, Hero 4, Hero 3+, Hero3, Hero 2, Hero HD, GoPro Camera accessories : Camera & Photo

2x plastic end caps (I have a bunch of spares PM me if you want some): 8 Pcs Black 25mm Dia Blanking End Caps Covers Tube Insert Bung | eBay

2x small U Bolts

2x Wing nuts

Everything is really easy to make and the only hard part is drilling the holes through the carbon tube so they line up perfectly on both sides. Luckily I found an article that shows how to drill a tube without a drill press. Very good tip since I ruined my first carbon tube. Tech Tips: Drill a Hole in a Pipe Without a Drill Press | Radio magazine

Here is a sample vid that I made with my Virb XE using the mount and an OBDII reader. Hope you guys enjoy.

https://youtu.be/J6Y0H0HEEGc

My take on the Garmin Virb XE. :tup:

http://www.the370z.com/track-autocro...ng-bundle.html

Mounted front and center with the suction mount.

https://www.youtube.com/watch?v=QxuZldssGNk&t=3s