Quote:
|
Quote:
|
In my case the windows occasionally would not roll us after I open the door then close it. If j opened the door again and closed it it would be fine. Reset procedure didn't do anything so eventually I just bought a new sensor/switch for the door and it solved it.
Sent from my SM-G900F using Tapatalk |
Quote:
|
I replaced the part the door closes on and that reads closed or open.
Sent from my SM-G900F using Tapatalk |
Quote:
|
Yep
Sent from my SM-G900F using Tapatalk |
Quote:
|
Quote:
|
Quote:
|
Fixed! I tightened the screw holding the sensor switch while pressing it it down. All is good now, window is functioning like before!:happydance:
Thanks again scottIn! |
Wonder if mine in loose.
|
Quote:
|
Well now this morning the passenger side window cracked like it's suppose to, but then didn't go back up. After opening and closing again, it went back. Not digging this.
|
So, what ever happened with this?
I'm pretty sure mine did this yesterday again, which would make twice now. Here's what I think is happening 1. Open door, window doesn't go down like it's supposed to 2. Close door, and don't hear the "zppp" noise or see the window go up 3. Go "wtf" and open door again, and the window goes down. I know the window probably doesn't seal right without the window being down & going back up after you shut the door, but I'm concerned there is an interference issue between the top of the window and the car body, is that the case? I hope not. I don't see any damage. I pressed and released the little switch in the door jamb that senses whether the door is closed about 20 times and the window went up and down as expected. :ugh: |
All times are GMT -5. The time now is 06:43 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2