|
You might need a drill.. Assuming the GTM core uses the same crossmember bracing that the Z1 core does.. Not a huge deal.. just take the bumper off (roughly 18
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
06-13-2013, 03:10 PM
|
#4 (permalink) |
|
Enthusiast Member
 Join Date: Sep 2012
Location: Marysville Ohio
Age: 39
Posts: 357
Drives: 09 Nissan 370Z 6M
Rep Power: 14  |
You might need a drill.. Assuming the GTM core uses the same crossmember bracing that the Z1 core does.. Not a huge deal.. just take the bumper off (roughly 18 screws / bolts, 10 push pins) and a 10mm socket to unloosen the washer bottle a bit. Then route the lines, tighten down the bolts for the core, attach the hoses at both ends. Torque down the sandwich plate adaptor and you're good
 . Go to Z1 and download their PDF for installation. Takes about an hour.. Good Luck
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved) | djpathfinder | DIY Section (Do-It-Yourself) | 21 | 11-30-2015 05:47 AM |
| Nissan Motorsports Oil Cooler vs. Stillen Oil Cooler | Dustin@Z1 | Engine & Drivetrain | 158 | 03-10-2014 02:27 PM |
| [FOR SALE] AT Transmission Cooler with Setrab 19 Row cooler | zakimak | Parts for sale (Private Classifieds) | 4 | 03-03-2012 11:44 AM |
| Info | ogm.k4b | New 370Z Owner | 6 | 11-22-2009 04:11 PM |
| Need some info. | bossman | The Lounge (Off Topic) | 5 | 01-09-2009 12:28 AM |
Threaded Mode
