Yea I know. I already corrected myself a few post later. Read threw please.

16hr X $100 = $1600 for labor.
$700 for the JUN cams.
$250 for a Uprev re-tune
Not to mention possible $$ for new springs

~$2550 total.

For me to justify this mod, minimum gain of +20WHP is a must.

Ok guys found an install car going under the knif this week

I know but I figured I would throw real times into the discussion as everyone is using guesses and approximations, just trying to help a little.

I'm not extremley familiar with AllData and the time guide they use but if that is warranty time as per Nissan than getting an outside shop to do that for an aftermarket cam install is a steal. Normally customer pay is 1.5x warranty so that would be 24.5 hours for this job, assuming AllData uses warranty times and there are no addition op codes for this job.

I'd like to have this mod also. But I know one day Ill be FI (TT) wit built motor. Probably best to wait then. Being the motor will be tore apart anyways theres really not much add cost in doing this.

:tup:

Can't wait to see results

Sick! Gotta see those sound clip vids of before and after...... or....... At least after!

I'm in for videos.

Congrats!

But.. baseline dyno???

You really need that to determine anything!

Cams=:yum:

I already have a base line will dyno again before cams get slapped on and after dyno for sure as well as before and after sound clips hope all goes well with the install wish me luck guys

Good Luck man. This company better be forever grateful to you cause if this works and makes some decent power there gonna make some serious money.

If you net even a small gain i'll get these as part of this winters build up and group buy should go into effect ^__^

thanx guys, hope they really yeild good gains im expecting at least 15hp pluse according to JUN