Oil spilled while filling up.

cab83_750 · 02-10-2010, 01:42 AM

Minicobra,

don't worry about the cap. My latest screwup was 2 weeks ago. I had to drop the engine and tranny on my car to replace the clutch, t.o. bearing, etc.

3 hrs later the starter would spin but the motor would not turn. 15 minutes later performing problem analysis, I found out that I had forgotten to install the 'starter gear ring.'. Obviously, I had to spend another 4 hours dropping the engine and tranny again. !!!!!!

Minicobra1 · 02-15-2010, 01:07 AM

Quote:

Originally Posted by cab83_750

Minicobra,

don't worry about the cap. My latest screwup was 2 weeks ago. I had to drop the engine and tranny on my car to replace the clutch, t.o. bearing, etc.

3 hrs later the starter would spin but the motor would not turn. 15 minutes later performing problem analysis, I found out that I had forgotten to install the 'starter gear ring.'. Obviously, I had to spend another 4 hours dropping the engine and tranny again. !!!!!!

Whaaaaaaaaaaaaaaaaat

that sucks.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

02-10-2010, 01:42 AM	#1 (permalink)
cab83_750 Track Member Join Date: Apr 2009 Location: CA Posts: 887 Drives: 09 NISSAN 370Z Rep Power: 419	Minicobra, don't worry about the cap. My latest screwup was 2 weeks ago. I had to drop the engine and tranny on my car to replace the clutch, t.o. bearing, etc. 3 hrs later the starter would spin but the motor would not turn. 15 minutes later performing problem analysis, I found out that I had forgotten to install the 'starter gear ring.'. Obviously, I had to spend another 4 hours dropping the engine and tranny again. !!!!!!