|
Yes. Comment- If Nissan Engineers wanted a bleeder port fitting, (a T or a 3-way) then it would be there. I thought why isn't it? Perhaps the potential to leak
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
12-01-2024, 10:20 AM
|
#16 (permalink) |
|
Base Member
Join Date: Nov 2022
Location: SLC, Utah
Posts: 14
Drives: 2016-WhitePearl-370Z
Rep Power: 4  |
Yes. Comment- If Nissan Engineers wanted a bleeder port fitting, (a T or a 3-way) then it would be there. I thought why isn't it? Perhaps the potential to leak is greater and O-Rings can and do become more rigid/brittle over time. Considering the exposure to a more heated environment that is even more likely to occur and leak. So it made more sense to me and went this route. *I do like what "1st", mentioned in his previous comment. Rock on Bro!!
__________________
Did you know if you put your ear up to a stranger's leg you can hear them say, "What the **** are you doing?" Last edited by VR4NIN; 12-01-2024 at 12:06 PM. |
|
|
|
12-04-2024, 01:29 PM
|
#17 (permalink) | |
|
A True Z Fanatic
Join Date: Jan 2016
Location: Atlantic SE
Posts: 1,361
Drives: '10 K23 ST 7AT
Rep Power: 30527  |
Quote:
__________________
Toys Not Tots |
|
|
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4" heater hose | halonut | Engine & Drivetrain | 5 | 02-28-2020 09:19 AM |
| Clutch Bleed Screw | Herb Hoover | Engine & Drivetrain | 4 | 10-06-2018 10:38 PM |
| Heater Hose replacement & bleeding cooling system | nis350 | Engine & Drivetrain | 8 | 08-13-2018 12:50 PM |
| Searching for bleed valve/screw | mishuko | Canada | 2 | 04-14-2016 09:41 PM |
| Help.. Heater hose install | NeverBoneStck | Engine & Drivetrain | 4 | 08-09-2015 01:03 PM |
13Likes
Linear Mode
