|
Sorry guys, I guess I didn't explain very well. The crank was turned after the main timing chain was pulled. I trying to line the top dead center (number one
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
10-03-2022, 02:38 PM
|
#6 (permalink) |
|
Base Member
Join Date: Sep 2018
Location: TX
Posts: 6
Drives: 12 Nissan 370Z Gy M6
Rep Power: 7  |
Sorry guys, I guess I didn't explain very well. The crank was turned after the main timing chain was pulled. I trying to line the top dead center (number one cylinder at the top) back to the exhaust lobe positions of the of the number one cylinder. I'm thinking the number one cylinder needs to be all the up and the exhaust cam lob needs to be in the position as shown in EM-58 26.b. manual. Would this be correct? Thanks for any reply.
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [WTB] Vlsd axle stubs - differential output shafts. | Hypoxic | Parts for sale (Private Classifieds) | 0 | 04-03-2022 09:49 AM |
| Strength of rear axles and drive shafts | Jinxx | Track / Autocross / Drifting / Dragstrip | 25 | 09-03-2018 04:29 PM |
| [WTB] oem crank shaft censor, aftermarket differential, z speed/z1 clutch slave cylinder. | DOOMMONKEY777 | Parts for sale (Private Classifieds) | 0 | 06-28-2014 04:32 PM |
| Diff Swap and new half shafts | mdxj | Engine & Drivetrain | 2 | 03-12-2014 02:40 PM |
| the crank shaft its harmonic balance? | vitinvictor1 | Intake/Exhaust | 100 | 01-21-2013 06:54 PM |
14Likes
Threaded Mode
