ZSpeed CMAK with a RJM clutch pedal??

stock12

From the Rev 3.x instruction manual on RJM's website:

dvboy

Thanks.....I believe these instructions were intended for the stock clutch/csc set-up,but I did contact Ryan at RJM and the same applies for the CMAK set-up as well(setting APF at 0% for bleeding).Joe at ZSpeed recommends leaving the RJM pedal in the stock APF (0%)position after the bleeding is complete.Ryan at RJM says u can adjust it to the 50-75% APF setting with the ZSpeed clutch/CMAK after the bleeding is complete.I am going to try it out at the stock 0% first and maybe bump it up to 25-50% if I want to change the feel a bit.

__________________
Pioneer AVIC 8000NEX,Hertz ML 1600,ScanSpeak D3004,Audison AV 5.1K,Helix DSP.2,Illusion Audio L10 Sub,RJM Clutch pedal,Stillen G3 long tube intake,Nismo exhaust,AAM S-line axle back,Ecutek tune