So something like the coolworx shifter is just out of my budget. But the zspeed is as long as no one tells the mrs I didn't need it :happydance:

That's heavier than most regular kits... Clutch 18-20lbs, Fly 17.5lbs... ;)

Got the trans out from under the car and cleaned up over the weekend. rjm pedal should be here today. I have 1 more question off to Joe. Once I hear back from him the order will be placed. With any luck it should be off the stands in 2-3 weekshttps://uploads.tapatalk-cdn.com/201...09e231b005.jpg

Sent from my SM-G965U using Tapatalk

I have the Z1 as well. How do you even go about adjusting it? I have no idea. . .

So here is the final shopping list for those interested. I did forget 1 thing, a new shift knob. Thinking about starting a new thread next to the what oil should i use to figure that one out :rofl2:

Zspeed stage 3 super street clutch, Cmak, oem cmc, ect

rjm v3.3 pedal

Torque Solutions Trans Mount

Zspeed Short Throw Shifter

New bolts, Motul fluids all around, all the hot stuff is getting wrapped to keep the hot in and the cold stuff double wrapped to keep the hot out.

fingers crossed in 3 weeks I'm looking to plan a break in road trip :happydance::driving:

Looking like tranny is sitting on a roll around chair :icon17:

I'm too old to wrestle it out without one. It's a little janky but it's getting the job done.

Sent from my SM-G965U using Tapatalk

Me too. Used to lay on my back and press cast iron case BW T10's and Hemi 4 speeds into place. That ain't happening anymore. The aluminum case Super T10's and the M21 and M22's wasn't bad.

Joe don't mess around with the shipping. Should have everything on Wednesday.

Sent from my SM-G965U using Tapatalk

Usually 1 day shipping for me from Zspeed. :rock: Cant argue with that.

JC's big azz broke 2 stools at my place. set a piece of mdf on the same trans jack and called it a rolling stool. :icon17:

Lmao. It's double duty

Sent from my SM-G965U using Tapatalk

Time to get busy:happydance:

http://www.the370z.com/members/-zs-c...le-o-parts.jpg

Trans is back home. cmak is done. All down hill from here.

Extra heat wrap on all the lines too, used dei cool tube. Really easy to work with, seems like it will help a bit

http://www.the370z.com/members/-zs-c...-cmak-line.jpg

"Last couple parts honey, I swear this is the last i need to finish up.":bowrofl:

VQ Vortex shift knob

got the gaskets on the way too. Should be it, I'm totally not over budget because I quit counting :ughdance:

I had a question ab the height and radius of that knob but **** it i'm buying it.

He is hefty at 6ft 6in. LMAO.

http://http://www.the370z.com/member...uttoned-up.jpg

Exhaust gasket came in today. That is 100% of everything underneath except bleeding the clutch. Going to get it back on the ground and prep for the pedal/cmc swap this weekend

Got the pedal and cmc pulled. Will pick up on the install in the AM.


http://www.the370z.com/members/-zs-c...-pedal-cmc.jpg