Cold Air Intake

Quicksilvers

Once every year I clean my K&N cone style air filters with K&N power kleen cleaner and degreaser. You let the air filters soak for about ten minutes to loosen the dirt and grime in your dirty air filters after they have been completely sprayed with the K&N power kleen cleaner and degreaser. Then rinse off your air filters with cool low pressure water from the clean side out in order to flush all the dirt and grime out of the filters. Then let your air filters air dry in the sun for about one or two hours. Do not re oil your air filter if it requires to be oiled until the air filters are completely dry. After the air filters are completely dry you can evenly oil your air filters but make sure not to over oil your air filters as over oiling your air filters can possibly damage your mass air sensor. Allow the air filter oil to wick for about twenty minutes and wipe off any excess air filter oil with a clean rag. Then you install your clean air filters. After about one year of normal use I noticed my air filters were dirty and needed to cleaned and oiled with a K&N air filter recharge kit. You also simply just replace your air filters if they are old showing signs of wear or you don't or can't wait to take the time to clean and oil your air filters it's your choice. The Stillen Generation 3 long tube cold air intake is one of the better long tube cold air intake kits I have seen for the Nissan 370Z with very good fitment. The Takeda long tube cold air intake is great choice also with very good fitment too. Be careful which brand long tube cold air intake you purchase because they don't all fit the same. Some brand long tube cold air intakes need to be adjusted or even cut to fit properly. Removing the front bumper cover is pretty simple just be careful when removing it and have something to set it on.