DIY Yaw Sensor rocker switch

Originally Posted by BGTV8

Mine is done, used crimp connectors and ratchet crimper and mounted the rocker switch in the spare panel between heated seat switches.

Since I am a 2009 model, isolating the yaw sensor illuminates both VDC and "slip" warning lights. To re-enable, the ignition needs to be cycled.

Takes about a half-hour and the most difficult issue is stripping the insulation off the green wire. In the end , I elected to hold the wire with long-nose pliers and used a sharp knife to score the insulation which then pulled off between my fingers as there was not sufficient room to use my wire stripping tool.