DIY: LED Halo w/Video's

l2iceman

Looking good! Regarding the sma projector for the turn signal, I thought people stopped doing this because having a projector there caused it to magnify sunlight heat and cause paint to bubble in front. Or was that due to bad prep work?

Sent from my SM-N920W8 using Tapatalk

R1talin

Thanks, not sure about the paint bubbling....if i have any issues with it ill post up.

Genosphere

Ya that is an issue and after sitting in the sun a little to much i got some melting/warping of the paint just below the projector. If i were to move it back a little more i think i could of prevented it. I though of wrapped the plastic just under it with either a clear piece or matching color to get around it. May do so if i take them apart again, or just wrap the whole damn thing.

Either way the headlight themselves are functioning grate, minus the morimoto demon eyes. I either missed the opening in the housing just by a few mm or the opening does not let enough light through.

If anyone wired a switch to manually turn them on or off via switch inside the cabin, let me know how and where you ran the +/- line to whereever inside the cabin.