Diy spc toe bolt install (MISTAKE) HELP

RedBullRR

I could not find a DIY for this mod, and went ahead and started the install. I put the rear camber arms in with no problems. However when installing the Toe Bolt and enlarging the hole I made the hole larger for the toe bolt that goes were the camber arm goes and not the spring bucket.

Below is a DIY for the 350Z that states this goes were the spring bucket goes.
http://www.batit.com/forumpics/spctoeboltinstall.pdf

My questions... Obv I have to remove those bolts now and place the stock ones back on. Did I **** up my cars toe by making those holes bigger?

__________________
2010 Solid Red Z: Mods: Stillen G3 Intakes | BC Coilovers | H&R 20/25 Spacers | Stillen Splitter | Stillen LW Pullie TBI | Red GTR Start | LED Interior | Kenwood Double Din

Mandingo

I'm assuming you made the camber slot bigger by accident right? (where the camber arm connects and has a large washer)

It should be ok but you need to get an alignment immediately if you haven't already.

__________________
some mods

RedBullRR

Yeah i made the slot bigger for the camber arms but went ahead and got the car aligned and all is fine. Love having the camber rite in the rear.

__________________
2010 Solid Red Z: Mods: Stillen G3 Intakes | BC Coilovers | H&R 20/25 Spacers | Stillen Splitter | Stillen LW Pullie TBI | Red GTR Start | LED Interior | Kenwood Double Din