DIY-Door handle removal
 

I know there's already has DIY by 209Z http://www.the370z.com/diy-section-d...r-handles.html , but had no pics of installation. So here it is:driving:

Tools Required:
Rachet&10mm socket
Flat head screw driver(for


Driver's
1. Locate& remove 2 rubber grommets.
http://www.the370z.com/members/bumbl...ure26781-1.jpg
http://www.the370z.com/members/bumbl...ure26782-2.jpg

2.unbolt the 3, 10mm bolts. 1on top hole and 2 on bottom hole.
*Be careful Screw can fall inside the door. I used magnetic screw driver*
http://www.the370z.com/members/bumbl...ure26785-5.jpg

3.pull up & out on the door handles.
http://www.the370z.com/members/bumbl...ure26786-6.jpg

4.You will see two wires. One for the Keyless entry(black wire) and other wire to physically open the door(Metal wire). Pop out 2 clips that holding the black wire and disconnect. And pop out the metal wire.
http://www.the370z.com/members/bumbl...ure26787-7.jpg

5. Driver's side done. Take 5 min brake:excited:


Passenger's

The only difference between Driver's and Passenger's is number of bolts.
Driver's has 3 10mm bolts and Passenger's has 2 10mm bolts. Other then its almost same.




All Finish!! Do whateva u want!! (Paint or Replace with others)
I swapped mine with Simot1's CF door handles. Thanks Simot!!

http://www.the370z.com/members/bumbl...1-img-0397.jpg

http://www.the370z.com/members/bumbl...0-img-0400.jpg


+Rep Me if I helped.

yay. Thanks for updating with pics! =]
+ rep homie!

Nice write up :)
I might add that once you detach the Driver side handle? That both windows will automatically roll down as a safety precaution, And will have to be reset once reinstalled.

In that case, might as well at the reset procedure to this thread:

1. Turn the ignition from OFF to ON, you don't have to start the car for this. Just press the start button until it gets to the ON state, usually OFF > ACC > ON.
2. The airbag light should turn on, wait until it turns off (it should stay on for 7 secs and then turn off) and then turn the ignition to OFF within 1 second.
3. Wait more than 3 seconds after the ignition turns OFF.
4. Repeat steps 1 to 3, twice. (Total 3 times)

BAM TEAM WORK WOOOT!!!! haha (NOS energy drink)

:tiphat:

AWESOME... Been waiting for a DIY with pics.

Got a spare set of handles here already painted and waiting for install :tiphat:

Oh, man, if you do this, you'd better come out so we's can see it in MD!

I just need some warm weather LOL.

looks nice man

Thanks docaam:tiphat:

Thanks for that. I might be doing something with mine soon and that'll really help :)

Can you clarify this....are you saying once i remove the cover from the second hole that there's going to be 2 10mm bolts in there?

Thanks

Done..YAY..!!

Thanks to "Bumblez" for doing pics for this DIY :tiphat:

http://www.the370z.com/members/troop...7-dscn1378.jpg

http://www.the370z.com/members/troop...6-dscn1377.jpg