DIY: Show-n-Go Front License Plate Install (Grill Location)

Originally Posted by Boost_lee

Thanks Jeff

As for the center location - it can be done. The only difference is that there is a metal beam in front of the radiator at the center of the car. This is the same beam that holds the Nismo body dampeners. Since this beam is there, the Show-n-Go assembly will sit .5-1 inch farther out of the bumper. Also, there is an ambient air temp sensor there that may/may not need to be located. It is certainly possible, but I didn't want to mess with this, especially with the bumper still attached.

On a side note, chances are that you are not going to have this plate in the displayed position very often. My plate is a little crooked, but I don't mind since its hardly displayed. If you do drive around a lot with the plate displayed, and only need it down for certain occasions, then I'd probably save a few bucks and get the non-motorized version.