Swift Spring Install Issues

sandersd

I think that's a good choice. As for the nut, the kicker is having to hold the shaft - that excludes using a socket. I came up with a workable solution for using a torque wrench in combination with the box end to actually torque the nut, but I still haven't figured out how one would hold the shaft without some type of specially designed tool (besides vice-grips of course). Also, without the special tool that holds the shock in a vice it'd be difficult to torque to spec without the shock turning, and I don't want to clamp the shock tube itself for fear of damaging it.

I'm going out this morning looking for a decent shop to install the springs on the shock, then I'll install the rear springs and SPL replacement arms.

__________________
2014 370Z NISMO -- HKS Hi-Power Exhaust -- Swift Springs -- BC ER Coilovers -- SPL Suspension Components -- Nismo R-Tune Intake -- Seibon BD CF Hood

sandersd

Finished the first side this morning with no issues. Yahoo! The service manual says to torque the front lower shock absorber bolts with the tires on the ground in the uladen position. As low as this car is I'm not sure that's realistic without an appropriate lift.

IMG_0737.JPG
IMG_0738.JPG
IMG_0736.JPG

Also removed the other front shock/spring. Took ten minutes. Go figure. I decided to take them to the local Nissan dealer five minutes from my house. If anyone is set up to do it properly I have to assume they are.

IMG_0734.JPG

And found a screw in my tire
IMG_0735.JPG

__________________
2014 370Z NISMO -- HKS Hi-Power Exhaust -- Swift Springs -- BC ER Coilovers -- SPL Suspension Components -- Nismo R-Tune Intake -- Seibon BD CF Hood