Anyone kno torque specs for long bolt that goes on bottom of strut and the top 3 bolts on the engine bay

I wanna make sure i torque down to specs and dnt have service manual

Index of /FSM/370Z/Coupe/2010

http://www.nicoclub.com/FSM/370Z/Coupe/2010/FSU.pdf

Can you please tell me torque specs dnt have time. I work 16 hrs

The second link is the section of the fsm you need. It'll take you five minutes to read through it.

LOL he works 16 hours so he can't be bothered to click a link and read 2 pages.

I read it . I dnt see anything about torque specs

They should be listed in the pic by the bolts.

Because I'm a nice guy.

Pertinent fasteners have their torque specs in Ft./Lbs circled in red.


http://www.the370z.com/attachment.ph...1&d=1396014907

http://www.the370z.com/attachment.ph...1&d=1396014907

If you work 16 hours (a day?), where do you have the time to work on your car? I'd recommend that since you're having so much trouble, just pay someone at a shop to do it correctly.

Or is it 16 hours a week? Then that's a different story and just disregard above.

:iagree:

after reading this thread the OP has no clue, even when being told how to do it.

So that long bolt is 120 ilbs torque

Although this thread is quickly spiraling down to an example of Darwinism in action, I fear the potential for collateral damage done against innocent bystanders. I'm tempted to start a fund to pay for this kid's spring install.

At the very least OP, once you eventually get the car back to the point where you can drive it, immediately take it to a licensed mechanic to check the work and perform an alignment. Do not pass GO and do not collect $200.

Jeezus, this is scary to watch. :ughdance:

Finally installed springs . Car runs perfect. Only thing front driver side seem little higher . Is it normal for you swift giys ir will it break in and sit lower

:icon18: