|
I think most places will charge you like 50-100 bucks a corner. Plus if you get it corner balanced add some more cash on as well as an alignment. Preload
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
01-29-2013, 10:45 AM
|
#2 (permalink) |
|
A True Z Fanatic
Join Date: Aug 2011
Location: Laguna Beach, CA
Posts: 2,214
Drives: Nismo Z
Rep Power: 3066   |
I think most places will charge you like 50-100 bucks a corner. Plus if you get it corner balanced add some more cash on as well as an alignment.
Preload is simple, the rears are super easy to do... Preload is just raising the spring hatch to X amount usually a 1/4 to 3/8 of an inch with another jack and then lock it in with the rear strut by spinning it down/up to meet the hole the bolt enters into. --- Short story Fronts are always set with pre-load so you just swap out with the fronts. and Dial in whatever height you want. ***NEVER adjust while on the car- Take the entire assembly out adjust and then re-lock then reinstall ***
__________________
AMUSE * TOMEI * STILLEN * CRAFTSQUARE RECARO * 3M * TOP SECRET * SLICKCARBON |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C.B. Exhaust install average price? | 2004YZFR1 | Intake/Exhaust | 22 | 01-08-2012 02:30 PM |
| average cost of install | pyrrhus17 | Forced Induction | 15 | 09-23-2011 11:45 AM |
| How much would it cost (Nav/Speakers/Camera/Install) | papashango | Audio & Video | 7 | 12-07-2010 10:06 PM |
| Average install price for HFC? | TonyBPD | Intake/Exhaust | 19 | 11-16-2010 01:40 PM |
| S-Tune Install Cost? | blinkme323 | Exterior & Interior | 7 | 12-03-2009 03:39 PM |
3Likes
Threaded Mode
