Spec's on Whiteline Swaybars

[Valentino]

I was searching for spec's for these with no luck. So I e-mailed Whiteline and received this chart (Attached below).

This is quoted from the e-mail.

Hi,

All our sway bars are solid and yes a two hole adjustment is two settings and a three hole is three settings of adjustment.

As for % of stiffness we do not have information on each hole as on each different sway bar we make the increase would be slightly different as some arms are longer etc plus the fact they attach in different parts of the suspension.

A slight way to understand would be that say a 24mm on the middle hole of three hole adjustment is a 24mm bar stiffness.If it was to be on the hard setting it would be just under the stiffness of a 25mm sway bar.If it was put on the softer setting it would be around close to a 23 mm sway bar.

I have attached a page with swaybar stiffness comparison we hope this helps.

This is another replay.

this chart is not 100% accurate it is very close but some swaybars will be slightly different due to the appplication

As you probably already know your sway bars would have been hollow from factory hence why the swaybars we are making in solid will not be really that much larger as being solid they will be allot stiffer than a hollow bar of the same diameter