|
Check if axle center nut is tight. wheel would wobble too if it got loose. Rotate axle by hand and feel where the most feedback from clunk is coming from.
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-28-2019, 08:08 PM
|
#10 (permalink) |
|
Base Member
Join Date: Jun 2015
Location: Toronto
Posts: 69
Drives: 2016 370Z Base 6M GM
Rep Power: 12  |
Check if axle center nut is tight. wheel would wobble too if it got loose.
Rotate axle by hand and feel where the most feedback from clunk is coming from. With 37k even very hard miles its too early for issues@rear end. My G has 225k km with lots of track and autox time-still on stock axles.If you know anybody close to you with Z ask them to test their car. Z has drivetrain " lash", it might even be normal. Mine clunked since new if I was bit clumsy with clutch at very low speeds- like parking.
__________________
2016 370Z Base/Setrab/AEM/Uprev/M7 Japan/Magnaflow/Quaife/Wilwood/300 whp 2003 G35 sedan 6MT(good bye-after 15 years together  )
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Diagnosing noise and pulsing...bad wheel bearing? | ToTaLCHaoS | Brakes & Suspension | 3 | 11-02-2017 10:04 AM |
| REAR Wheel Well Noise - G37 wheel liners? | markesc | Audio & Video | 7 | 10-29-2017 11:21 AM |
| Is this Tire roar or wheel bearing noise. Just not sure | BlackCherry Z | Brakes & Suspension | 0 | 11-27-2016 02:58 AM |
| Track Junkies: What is your rear wheel bearing life ?? | BGTV8 | Track / Autocross / Drifting / Dragstrip | 11 | 06-19-2014 11:57 PM |
| bearing whine noise | cossie1600 | Engine & Drivetrain | 2 | 03-29-2012 10:47 PM |
Threaded Mode
