Help! With Lowering Springs And SPC Camber

Chuck33079 · 10-07-2016, 09:07 AM

Quote:

Originally Posted by Hotrodz

I had Teins on mine before I went with coil overs and all I needed were the rear camber arms and toe bolts. I think you can make some general assumption about our car set up, but until parts are installed and measurements taken you don't really know.

That's the rub. There's enough variance in tolerances from the factory that some cars need the whole setup, and some don't. The catch is that you end up re-doing all of the spring install labor to add arms after the fact if you end up needing them. So it's either extra work if you DIY and paying for an alignment twice, or even worse, paying for the install twice if you farm out the wrenching. It's almost big-picture cheaper to get them up front and just install them.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Tools needed to install lowering springs and rear camber arms.	BobbyLight	Brakes & Suspension	9	05-10-2016 12:16 PM
Room for camber and lowering??	snowhite370	Wheels & Tires	0	04-23-2013 03:42 PM
Camber kit with Swift Spec R lowering springs?	JAYNO20	Brakes & Suspension	13	08-29-2012 04:15 PM
Eibach lowering springs camber question...	pilatus	Brakes & Suspension	0	05-15-2012 12:04 AM
How much front camber after lowering?	bradsm87	Brakes & Suspension	2	09-17-2011 05:58 PM