|
I have a kenwood ddx714 using the factory wiring harness adaptor. The power for amp is running down passenger side. Now the amp is grounded well to the frame since
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
11-02-2009, 11:38 PM
|
#26 (permalink) |
|
Base Member
Join Date: Oct 2009
Location: Phx,AZ
Posts: 45
Drives: 370z 6spd sport mdl
Rep Power: 17  |
I have a kenwood ddx714 using the factory wiring harness adaptor. The power for amp is running down passenger side. Now the amp is grounded well to the frame since I sanded that spot. The remote on, rcas, and front speaker lines are all going down the driver side. I haven't tried regrounding the deck, but wondering if it may be that, or if I should run the rcas and remote down the center and leave the fronts speaker wires on the driver side door area and assume the deck is ok, since it never buzzed before I added the components, and amp, etc.
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1st gear noise | rench | Engine & Drivetrain | 105 | 12-21-2012 10:48 PM |
| Rear End Noise | bradz | Nissan 370Z General Discussions | 18 | 06-23-2011 05:04 PM |
| Noise issues | nuts4nissan09 | New 370Z Owner | 5 | 08-27-2009 12:46 PM |
| G37 engine and 370z engine | kannibul | Nissan 370Z General Discussions | 21 | 08-12-2009 01:58 AM |
| Tire Noise | dwhitley0381 | Nissan 370Z General Discussions | 0 | 06-11-2009 09:34 AM |
Threaded Mode
