Which speakers to get? (Simple install preferred)

Sagi

What's wrong with the amp that I listed? It's a 4 channel, can't I use 2 channels for the 2 polk speakers.. then the other 2 channel, bridge them to power the sub?

bigaudiofanat

If your going to run a sub with it you have to make sure the amp can run at 3 channels which i do not think the kenwood can. Also you have to make sure the ohms of the sub is going to be ok with a bridged channel. Most 4 channel amps are made to run bridged at 2 channels not 3 channels.

__________________
Need help with car audio or electronics? Let me know!! Need Help Let Me Know
Direct email address reimermatt@gmail.com
Owner of: Dynamic Mobile Audio Follow me below
https://www.facebook.com/Dynamicmobileaudio/

Sagi

From the looks of it, I think the amp can do 3 channels.

From Crutchfield : "You can bridge the rear channels to drive a subwoofer, while the front channels power your full-range speakers. The built-in high- and low-pass filters let you tailor the amp's output so you can dial in the best possible performance for the speakers in your vehicle."