09-04-2009, 01:30 AM
|
#17 (permalink)
|
|
Base Member
Join Date: Aug 2009
Location: Hawaii
Posts: 82
Drives: 370Z Base/Sports
Rep Power: 15
|
Quote:
Originally Posted by rreign
This can go a couple of different ways, but my suggestion for just ease of the install is to leave the OEM wiring where it's at and just connect your speakers straight to the OEM wiring. Then run your speaker wire from the harness to your amp. Connect the RCA's, set your gain and voila. (For a tip on setting your gain you can check here... Rockford T212D2 too much for 370z?
Also, yes you would run your door/dash in parallel. |
Sorry to bring this back from the dead...but I'm a bit confuse. So you would connect the oem wire to new speaker (using appropiate connectors). Now keep the oem wiring connected to the oem harness-->connected to metra harness-->connected (with connectors) to Kenwood harness-->connected to the 7140 unit. Now how would I connect the speaker wires from there to the amp? Thanks!
|
|
|
Similar Threads
Threaded Mode
