Crux swrns-63u

ZStalker505 · 06-06-2023, 05:36 PM

Anyone used this with a kenwood hu? the instructions have the steering wheel control cable that comes out of the module box with only one wire that gets connected to the kenwood hu. This seems to simple to connect the steering wheel controlls up... HU is a DMX8709S btw
Screenshot 2023-06-06 162744.jpg

As far as I can tell the only connection is the single wire blue/yellow on the back of the HU no place for the 3.5mm plug
Screenshot 2023-06-06 163441.jpg

ZStalker505 · 06-08-2023, 11:02 AM

Got a reply from a rep and they stated "For Kenwood you only use that blue/yellow wire you cap off the 3.5mm plug." Seems to easy but I'll find out if it works.,

ZStalker505 · 06-12-2023, 10:38 AM

for anyone that cares the install of this was silly simple and it works perfectly, if your doing a Kenwood deck like I did its literally one wire, set the module box following the instructions and plug it in

06-06-2023, 05:36 PM	#1 (permalink)
ZStalker505 Base Member Join Date: Jan 2023 Location: NM Posts: 152 Drives: 14 SC Nismo Rep Power: 2	Crux swrns-63u Anyone used this with a kenwood hu? the instructions have the steering wheel control cable that comes out of the module box with only one wire that gets connected to the kenwood hu. This seems to simple to connect the steering wheel controlls up... HU is a DMX8709S btw Screenshot 2023-06-06 162744.jpg As far as I can tell the only connection is the single wire blue/yellow on the back of the HU no place for the 3.5mm plug Screenshot 2023-06-06 163441.jpg

06-08-2023, 11:02 AM	#2 (permalink)
ZStalker505 Base Member Join Date: Jan 2023 Location: NM Posts: 152 Drives: 14 SC Nismo Rep Power: 2	Got a reply from a rep and they stated "For Kenwood you only use that blue/yellow wire you cap off the 3.5mm plug." Seems to easy but I'll find out if it works.,

06-12-2023, 10:38 AM	#3 (permalink)
ZStalker505 Base Member Join Date: Jan 2023 Location: NM Posts: 152 Drives: 14 SC Nismo Rep Power: 2	for anyone that cares the install of this was silly simple and it works perfectly, if your doing a Kenwood deck like I did its literally one wire, set the module box following the instructions and plug it in