Quote:
Originally Posted by UFreefer
True but the hp/tq curves will not change...the numbers might vary a bit. You could use that arguement for any dyno that was not done on the same day including the Stillen/FI comparison...so why not compare the stock vs FI? No big deal though, good write up
|
Well, post 96 above shows my tq curve from before the Stillen header install. Give my analysis in that post a quick read if you haven't already and tell me if you think it makes sense.
__________________
"There are no small accidents on this circuit." -- Ayrton Senna
316.8whp & 248 ft/lbs (Dyno Dynamics) | 319whp & 256 ft/lbs (DynoJet) (04/23/10)
Stillen G3 CAI, CBE, Pulley / F.I. LTH / GTSpec Ladder Brace / Setrab Oil Cooler / UpRev-tuned by Forged Perf.
|