Quote:
Originally Posted by ByThaBay
I'm in the process of ordering this. Is the removal of the manifold intercooler component fairly straight forward? Like others have mentioned, I want to avoid removing the manifold if possible.
Can I just pull the unit straight out?
|
Yes, but be aware that on the far end of the Stillen heat exchanger it is attached to the inside of the manifold with strong double sided tape. When you pull the heat exchanger out the tape will come apart and some of it could fall down into the intake runners. To prevent any junk from falling into the engine I would remove the rear throttle body and run a vacuum hose in it to the rear of the manifold (where the tape is) so that any tape that tears loose will get sucked up by the vacuum as the unit is being pulled out.
I removed mine prior to installing the manifold because I went with the A2A from the beginning. You will have to really pry on it but it will come out.
__________________
RJM pedal, Hotchkis Sway Bars, FI TDX, FOG Light, Z1 Slotted Drilled rotors, Stillen SC, Quaife ATB, Z1 Oil cooler, AEM Gauge Set, Galeforce gauge mount, Avant Garde M590 Hypersilver w/RE-11, TopgunZ A2A kit., ECUtek tuned by Seb: ROLL TIDE!
|