Nissan 370Z Forum - View Single Post

derraj06 · 10-23-2015, 12:56 PM

Daelen can correct me if I am wrong but this would most likely perform better than oem with a light weight flywheel. If I'm not mistaken, the oem pulley is not a balancer, only a vibration damper as is the dual mass flywheel. If you remove the dual mass wheel then the vibration could increase. Adding this dampening pulley should help decrease the vibrations, especially at higher RPMs.

If you guys want a tester for this, I'll add myself to the list for the group buy and put one on with my sub 2lb clutch and lightweight steel flywheel. It will be one of the most light weight setup a Z will see.

10-23-2015, 12:56 PM	#14 (permalink)
derraj06 Enthusiast Member Join Date: Jun 2013 Location: Huntsville, AL Posts: 406 Drives: MB 370z Rep Power: 11	Daelen can correct me if I am wrong but this would most likely perform better than oem with a light weight flywheel. If I'm not mistaken, the oem pulley is not a balancer, only a vibration damper as is the dual mass flywheel. If you remove the dual mass wheel then the vibration could increase. Adding this dampening pulley should help decrease the vibrations, especially at higher RPMs. If you guys want a tester for this, I'll add myself to the list for the group buy and put one on with my sub 2lb clutch and lightweight steel flywheel. It will be one of the most light weight setup a Z will see. Last edited by derraj06; 10-23-2015 at 12:56 PM. Reason: iPhone nazi autocorrect sucks.