Nissan 370Z Forum - View Single Post

Baer383 · 06-24-2012, 07:43 PM

I'm bring the thread back from the dead b/c after checking my data logs on my MAF volts they are maxed out @5.03 volts now my car pulls hard but high RPM it doesn't quite pull as hard as it has in the past.

And by the way I'm @471rwhp and on meth it is 496rwhp well below the 600rwhp people have stated the stock MAF are good for.(I have a GTM Stage 1.5 SC 11psi)

On the Cipher bank 1 and bank 2 are very consistent until the volts start going up high,then bank 1 is very erratic and it my be bad(I haven't got that far).(also been throwing code P0106)

Anybody has any comments or advise chime in as I'm doing my homework now.

06-24-2012, 07:43 PM	#24 (permalink)
Baer383 A True Z Fanatic Join Date: Aug 2010 Location: Lawrenceville,Ga Posts: 4,293 Drives: My foot up your azz Rep Power: 29	I'm bring the thread back from the dead b/c after checking my data logs on my MAF volts they are maxed out @5.03 volts now my car pulls hard but high RPM it doesn't quite pull as hard as it has in the past. And by the way I'm @471rwhp and on meth it is 496rwhp well below the 600rwhp people have stated the stock MAF are good for.(I have a GTM Stage 1.5 SC 11psi) On the Cipher bank 1 and bank 2 are very consistent until the volts start going up high,then bank 1 is very erratic and it my be bad(I haven't got that far).(also been throwing code P0106) Anybody has any comments or advise chime in as I'm doing my homework now. __________________ 2013 ZL1 754 rwhp 747 rwtq Last edited by Baer383; 06-24-2012 at 07:57 PM.