Okay so not on the bolts but the back of the spacer that is in contact with the hub?

yes correct

Im pretty sure this question has been answerd.... SORRY, but i have stock 19"rays I want 20mm spacers all around and swift springs... I should have no problem with rubbing right... Ive seen around forum that there is no problem.. Just confirm.. thank you guys

Finally installed the H&R 20 mm front and 25 mm rear bolt-on spacers. Quality is so much better than the Ichiba V2s I ran on my 350Z. Installation was a breeze with zero issues. Now, if only the Swift springs would get here a little faster. Here some before and after pics:

Before:
http://i1043.photobucket.com/albums/...ps7f5f4433.jpg

After:
http://i1043.photobucket.com/albums/...ps8579f12d.jpg

http://i1043.photobucket.com/albums/...ps1f60cd85.jpg

Any issues with vibration at high speeds??? With those 25mm

No problems whatsoever. As long as they're installed properly there won't be any issues.

Thank u

It's all in the angle of the photograph. A few of mine...

H&R Front 20mm stud replacement: Rear 25mm bolt on
Swift Springs
Tires - RE11 Fr 265 / Rr 285

https://lh4.googleusercontent.com/-k...rp_clarity.jpg




https://lh3.googleusercontent.com/-z...rp_clarity.jpg




https://lh5.googleusercontent.com/-O...rp_clarity.jpg


.

^^Beautiful!! Any particular reason you went with the stud replacement up front rather than keeping it bolt-on spacers all around??

^ Thanks, at the time back in 2009 - H&R did not manufacture 20mm bolt on spacers for our cars. You guys now picking up 20mm's are lucky !

Do you need alignment after you install spacers? 20mm all around?

NO. Only when you lower the car are you messing with the alignment.

Thank you!

:iagree: ^ :tup:

can anyone verify the spare tire will work on either end of the car with 20mm front and 25mm rears?