I'm installing some new shoes and the rears are 19x10.5 +25 with 305/35-19 Pilot Sport. I'm debating adding either a 10mm or 15mm spacer. My question is this; if I install the 10mm and decide I need the extra 5mm, could I just "add" a 5mm spacer or do I (should I) just replace with a 15mm?

Word of advice go with 20s or 25s. 305s are already a lil wide so they will poke out, but 15s are still gonna have a lil sunken look. Unless you arent going for the full flush? Also are you lowered? If so the larger spacers look better on them. Im running 20s and 25s on19s and they are perfect with 255-305 hankook V12s :tup:

I'm lowered on TEIN S-Techs. I have 25mm now with stock Rays. I put the new shoes on and it stuck way out. I pulled the 25s off and I purchased some 10mm nylon spacers at the hardware store to experiment, and it pokes a bit. I'm also running a -1.2 camber.

I noticed your on stock Rays, so 20-25 would be perfect. That's what I had. But my offset is different (+25 vs.+30 on the Rays) and my rims are 10.5 vs. 10.

I'll post a pic tomorrow....
.
.
.

gotcha, throw up the pics it should look good. :tup:

I ran the numbers and I'm picking up a set of H&R 10mm on the way home from work.....

I measured what a 15mm would look like and it looked like too much poke.

Yeah im lowered on tein s tech and really? dam well, I guess your defintion of poke is diff then mine. :icon17:

Here take a look with 25 in the back, its sitting perfect flush. So I would think a 10-15mm would be still look a lil sunken. But yeah your offests are diff as well as your diameter. Well post a pic when you are done anyways. :tiphat:

Will I need to change the configuration of the weights on my wheels if I add spacers? I ask because after getting my wheels powder coated the added weights to balance the wheel.

Here are the pics:

http://i269.photobucket.com/albums/j...ps124c3b4b.jpg

http://i269.photobucket.com/albums/j...ps43909197.jpg

http://i269.photobucket.com/albums/j...psb534db57.jpg

This is a 19x10.5 +25 with 10mm spacer and Michelin 305/30-19 lowered on TEINS. I think it sits about right. The side wall all around pokes a bit and a bit of the tread at the top. Fronts aren't on yet....
.
.

Niceeeee looks great!! :tup:

Will I need to change the configuration of the weights on my wheels if I add spacers? I ask because after getting my wheels powder coated the added weights to balance the wheel.

bump

can anyone confirm whether or not the spare tire will fit with 20mm front and 25mm rear wheel spacers? if it won't fit i wont have any issue pulling that extra weight out of the car.

I dont think there are any issues with using spare tire on spacers

Sent from my SAMSUNG-SGH-I747 using Tapatalk 2

Stud Length
 

I currently have 10mm spacers, but purchased a set of H&R 15mm DRS spacers (want more poke) from a forum member that didn't come with the extended studs. I picked up a set of Ichiba studs from Conceptz and they stated they would work, but they appear too long for use with closed end lugs. Does anyone know the correct length stud to use and/or a part number?

Thanks :tiphat:

Do your 10's use stock studs?