|
You can install this even if you don't have the AEM ECU. An AEM ECU and datalogging are not required but available if you want to do that later. Most
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
10-02-2010, 09:07 AM
|
#4 (permalink) |
|
Base Member
Join Date: Sep 2010
Location: East Coast
Posts: 13
Drives: TTZ, wants a Z34 too
Rep Power: 16  |
AEM UEGO Wideband
You can install this even if you don't have the AEM ECU.
An AEM ECU and datalogging are not required but available if you want to do that later. Most likely you'll datalog only and that's only if you feel like it. The installation is very easy: 1. get the supplied bung installed and welded for ~$20 OR use the new $40 non-weld bung that clamps on w/ a gasket. 2. tap into a 12v power source that is SWITCHED with your ignition for the car RUNNING. Don't connect it to an ACC power that is on w/ the engine off. 3. ground it. 4. mount the guage 5. run the cable from the WBO2 to the Gauge done. Not sure what tuners are using for target A/Fs. I have a TT so I target 11.5 at WOT and 14.7 at idle. I don't mess w/ the Nissan or JWT tune between those to situations. I already posted that question in the Tuner section but have not received a response yet. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS Stock Rays 4100 Miles MINT | Mr&Mrs | Parts for sale (Private Classifieds) | 10 | 08-09-2010 08:45 PM |
| FS: 52mm Depo Wideband AFR LED Gauge *NEW* | DIGItonium | Parts for sale (Private Classifieds) | 0 | 07-14-2010 06:52 PM |
| F/S : Innovate LC-1 WideBand o2 Controller w/ Dynotune Gauge | sidewayz34 | Parts for sale (Private Classifieds) | 6 | 07-27-2009 11:36 PM |
| 4100 Rpm fuel cutoff? | Trips | Engine & Drivetrain | 6 | 07-08-2009 01:25 AM |
| What happened to the tire pressure gauge and speedo in the middle gauge cluster? | rbratton | Nissan 370Z General Discussions | 33 | 01-24-2009 10:28 PM |
Threaded Mode
