Nissan 370Z Forum  

Go Back   Nissan 370Z Forum > Search Forums

Showing results 1 to 25 of 199
Search took 0.01 seconds.
Search: Posts Made By: kentmo280z
Forum: Nissan 370Z Roadster (Convertible) 04-30-2019, 07:40 PM
Replies: 4
Views: 471
Posted By kentmo280z
Just checked out the service manual for my type...

Just checked out the service manual for my type of seat. Have to tear half the seat back apart to get to a part that locks the head rest in... SMH ... :)
Forum: Nissan 370Z Roadster (Convertible) 04-30-2019, 06:37 PM
Replies: 4
Views: 471
Posted By kentmo280z
Roadster Head Rest Removal

Trying to replace my driver's side headrest. (Roadster Sport Package) I have not been able to figure out how to pull it out of the seat back. Pushing the button, I can raise it, but it will not come...
Forum: Forced Induction 06-10-2018, 11:23 AM
Replies: 39
Views: 3,302
Posted By kentmo280z
If you want to quiet it down, you can run a...

If you want to quiet it down, you can run a filter off the outlet. , (I ran an L- shaped hose to a small K& N air filter) and wrapped the filter with foam. Made a huge difference in the noise. I...
Forum: Forced Induction 06-05-2018, 07:03 PM
Replies: 39
Views: 3,302
Posted By kentmo280z
Got grinder...? ��

Got grinder...? ��
Forum: Forced Induction 05-31-2018, 01:40 PM
Replies: 138
Views: 12,835
Posted By kentmo280z
sub'd

sub'd
Forum: Forced Induction 05-29-2018, 07:36 PM
Replies: 4
Views: 644
Posted By kentmo280z
I used the Fast Intentions Fast 500 fuel return...

I used the Fast Intentions Fast 500 fuel return kit, ID1100 injectors and the fuel pump (walbro 255 )that came with the gtm stage 1 kit.
( I upgraded to the stage 1.5 kit and kept the stage 1...
Forum: Forced Induction 05-29-2018, 06:33 PM
Replies: 4
Views: 644
Posted By kentmo280z
I have the 1.5 kit. Tried the 90, 88 & 85 mm...

I have the 1.5 kit. Tried the 90, 88 & 85 mm pulley's. I got best results from the 88mm pulley. the 85 mm pulley seemed to lose top end power. I was remote tuning at the time of the changes , but the...
Forum: Parts for sale (Private Classifieds) 01-30-2018, 07:26 PM
Replies: 5
Views: 866
Posted By kentmo280z
PM'd, waiting for a response???

PM'd, waiting for a response???
Forum: Forced Induction 10-19-2017, 02:05 PM
Replies: 2
Views: 667
Posted By kentmo280z
Are you priming it by blowing compressed air into...

Are you priming it by blowing compressed air into the system, with the top of the reservoir banjo bolt un hooked? Then shooting compressed air (8lbs) into the sealed off resv. opening. I used a...
Forum: Forced Induction 09-25-2017, 06:26 PM
Replies: 39
Views: 3,302
Posted By kentmo280z
3 of us use the qrj... with no issue, something...

3 of us use the qrj... with no issue, something to consider
Forum: Forced Induction 09-23-2017, 01:05 PM
Replies: 39
Views: 3,302
Posted By kentmo280z
I really can't remember... I have tried so many...

I really can't remember... I have tried so many valves that I can't recall.
I actually had a 2nd BOV pipe made as I kept having new flanges welded on. .I'm sure that it did flutter , otherwise I...
Forum: Forced Induction 09-22-2017, 05:32 PM
Replies: 39
Views: 3,302
Posted By kentmo280z
I tried both the Tial 50mm & the QRJ, with the...

I tried both the Tial 50mm & the QRJ, with the supercharger spring. I had to have a new flange welded on for the QRJ.
The 50 mm was way loud. I only used it for a very short period of time. The...
Forum: Parts for sale (Private Classifieds) 08-17-2017, 12:10 PM
Replies: 8
Views: 640
Posted By kentmo280z
Try : ortizcustompods.com They did mine and...

Try : ortizcustompods.com

They did mine and I was quite satisfied. Couple weeks turnaround if I recall.
Forum: Forced Induction 08-15-2017, 09:05 PM
Replies: 844
Views: 249,576
Posted By kentmo280z
Update on a new tune performed by Dynosty,...

Update on a new tune performed by Dynosty, Louisville, Ky.

2010, 370z Roadster

GTM Stage 1.5 S.C. w/ 88mm pulley ( Thanks for the pulley Matt!)

479 RWHP / 360 Tq.

9.5 PSI
Forum: Parts for sale (Private Classifieds) 07-25-2017, 01:25 PM
Replies: 5
Views: 763
Posted By kentmo280z
- This is the product literature from the...

-

This is the product literature from the vendor that I purchased these from.
Hope this helps,
Kent


"Set of 6 1000cc/min BOSCH fuel injectors. These are a DIRECT FIT for rail and...
Forum: Parts for sale (Private Classifieds) 07-25-2017, 01:15 PM
Replies: 5
Views: 763
Posted By kentmo280z
I will check with the original vendor and let you...

I will check with the original vendor and let you know.
Thanks
Forum: Parts for sale (Private Classifieds) 07-25-2017, 10:00 AM
Replies: 5
Views: 763
Posted By kentmo280z
Bump

Bump
Forum: Parts for sale (Private Classifieds) 07-24-2017, 06:02 PM
Replies: 5
Views: 763
Posted By kentmo280z
Bosch EV14 1000cc fuel injectors

SOLD: Bosch EV14 1000cc fuel injectors.
Used for 3000 miles. I had them cleaned and tested by the original vendor so I could resell them. Comes with adapters for 370Z wiring harness. Free shipping...
Forum: Nissan 370Z General Discussions 07-14-2017, 06:08 PM
Replies: 17
Views: 3,921
Posted By kentmo280z
Back in November I purchased a S.C. Stage 1.5...

Back in November I purchased a S.C. Stage 1.5 upgrade kit. I received everything, though in 2 shipments , 2 weeks apart from each other.
The MAF pipes did not fit my car , so I ended up fabricating...
Forum: Nissan 370Z Roadster (Convertible) 07-07-2017, 07:41 PM
Replies: 31
Views: 5,973
Posted By kentmo280z
There are no deals out there.... $900.00 + ...

There are no deals out there.... $900.00 +
BTW ,do not buy the replicas...they do not fit!!!!
Forum: Forced Induction 07-02-2017, 11:57 AM
Replies: 349
Views: 28,126
Posted By kentmo280z
If I decide to do so, I would not till winter....

If I decide to do so, I would not till winter. And , if I do change over and stay with the stage 1, I'll contact you.
Forum: Forced Induction 07-01-2017, 11:49 AM
Replies: 349
Views: 28,126
Posted By kentmo280z
Yes. Going to wrap the header and part of the...

Yes. Going to wrap the header and part of the cat. And part of the filter..
I may go back to stage 1. Stage 1.5 has done nothing for me.
Forum: Forced Induction 06-30-2017, 10:07 PM
Replies: 349
Views: 28,126
Posted By kentmo280z
And... This... Wonder what damage this has...

And... This...
Wonder what damage this has done to the Supercharger...
I'm going to pull the cat and wrap it I suppose...

122624
122625
Forum: Nissan 370Z Roadster (Convertible) 06-26-2017, 02:32 PM
Replies: 31
Views: 5,973
Posted By kentmo280z
Nismo Conversion

Here is a pic with the Nismo side skirts. 122588
Forum: Forced Induction 06-03-2017, 09:25 PM
Replies: 349
Views: 28,126
Posted By kentmo280z
Installing this kit was the biggest pain in the...

Installing this kit was the biggest pain in the a$$ of anything that I've done to this car. And I've done all the work except the clutch. At every turn this kit fought me. Maybe if the engine were...
Showing results 1 to 25 of 199

 
Forum Jump

All times are GMT -5. The time now is 07:31 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2