Nissan 370Z Forum - [For Sale] My 370z Aftermarket Part Out

Everything has been Sold.

I traded in the Z, so the aftermarket items I was able to pull off are up for sale. Prices include shipping to lower 48.

Injen CAI - - Now on Ebay: http://www.ebay.com/itm/150751781335...#ht_500wt_1156

Used for about 7k miles. Filters are a little bent from installation but were just cleaned and are ready to go. Intake piping has a few paint chips but I do no believe its noticeable when installed. Overall good condition. Includes all hardware.

https://lh5.googleusercontent.com/-Q...00/CAI_1_5.JPG

https://lh5.googleusercontent.com/-h...00/CAI_2_5.JPG

https://lh6.googleusercontent.com/--...00/CAI_5_5.JPG

https://lh4.googleusercontent.com/-v...00/CAI_3_5.JPG

OEM Springs - - Now on Ebay: http://www.ebay.com/itm/150751785705...#ht_500wt_1156

Used for 15k miles. I wont be surprised if these need to go to ebay.

https://lh5.googleusercontent.com/--...520Springs.jpg

CNT CBE - SOLD - Exhaust is in great shape. Used for less than 5k miles. Very good condition. It was the first one purchased as far as I know. We had to cut one of the supporting brackets. That bracket was removed from later versions because it would contact the driveshaft. I really liked this exhaust. By itself it sounded great but only loud under hard acceleration. It pairs well with HFC's if your looking for something louder under normal driving conditions. You will need to provide your own mounting hardware (nuts, bolts, washers, gaskets).

https://lh5.googleusercontent.com/-y...00/CBE_1_4.JPG

https://lh4.googleusercontent.com/--...00/CBE_2_4.JPG

https://lh4.googleusercontent.com/-i...00/CBE_3_4.JPG

https://lh6.googleusercontent.com/-w...00/CBE_4_4.JPG

CNT HFC - SOLD - Used for about 3k miles. Excellent condition. Sound great paired with the exhaust above. You will need to provide your own mounting hardware (nuts, bolts, washers, gaskets).

https://lh5.googleusercontent.com/-L...NT%2520HFC.JPG

EvoR Rear Fog Light - SOLD - Used for 5k miles. Excellent condition. You will need to provide some wire to lengthen the existing wiring as well as some double sided tape.

https://lh4.googleusercontent.com/-l...0/EvoR_Fog.JPG

EvoR CF Fang cover - SOLD - Has a dime sized rock chip where it is missing resin. I'm sure some DIY'er could fix it up if they felt like it. You will need to provide double sided tape to install.

https://lh5.googleusercontent.com/-t...800/CF_1_3.JPG

https://lh5.googleusercontent.com/-V...800/CF_2_3.JPG