My 370z Aftermarket Part Out
 

Everything has been Sold.

I traded in the Z, so the aftermarket items I was able to pull off are up for sale. Prices include shipping to lower 48.

Injen CAI - - Now on Ebay: http://www.ebay.com/itm/150751781335...#ht_500wt_1156

Used for about 7k miles. Filters are a little bent from installation but were just cleaned and are ready to go. Intake piping has a few paint chips but I do no believe its noticeable when installed. Overall good condition. Includes all hardware.

https://lh5.googleusercontent.com/-Q...00/CAI_1_5.JPG

https://lh5.googleusercontent.com/-h...00/CAI_2_5.JPG

https://lh6.googleusercontent.com/--...00/CAI_5_5.JPG

https://lh4.googleusercontent.com/-v...00/CAI_3_5.JPG


OEM Springs - - Now on Ebay: http://www.ebay.com/itm/150751785705...#ht_500wt_1156

Used for 15k miles. I wont be surprised if these need to go to ebay.

https://lh5.googleusercontent.com/--...520Springs.jpg


CNT CBE - SOLD - Exhaust is in great shape. Used for less than 5k miles. Very good condition. It was the first one purchased as far as I know. We had to cut one of the supporting brackets. That bracket was removed from later versions because it would contact the driveshaft. I really liked this exhaust. By itself it sounded great but only loud under hard acceleration. It pairs well with HFC's if your looking for something louder under normal driving conditions. You will need to provide your own mounting hardware (nuts, bolts, washers, gaskets).

https://lh5.googleusercontent.com/-y...00/CBE_1_4.JPG

https://lh4.googleusercontent.com/--...00/CBE_2_4.JPG

https://lh4.googleusercontent.com/-i...00/CBE_3_4.JPG

https://lh6.googleusercontent.com/-w...00/CBE_4_4.JPG



CNT HFC - SOLD - Used for about 3k miles. Excellent condition. Sound great paired with the exhaust above. You will need to provide your own mounting hardware (nuts, bolts, washers, gaskets).

https://lh5.googleusercontent.com/-L...NT%2520HFC.JPG


EvoR Rear Fog Light - SOLD - Used for 5k miles. Excellent condition. You will need to provide some wire to lengthen the existing wiring as well as some double sided tape.

https://lh4.googleusercontent.com/-l...0/EvoR_Fog.JPG

EvoR CF Fang cover - SOLD - Has a dime sized rock chip where it is missing resin. I'm sure some DIY'er could fix it up if they felt like it. You will need to provide double sided tape to install.

https://lh5.googleusercontent.com/-t...800/CF_1_3.JPG

https://lh5.googleusercontent.com/-V...800/CF_2_3.JPG

80 shipped for the fangs?

Yes sir. Please note the rock chip. I don't want you to be surprised.

still a good price. i'll mull it over.

I'll take the fangs... please PM me paypal info.

90 shipped for fang. Lmk

Sale pending to MattP725 on the fang cover.

$$ Sent! Bump for the CNT exaust and HFCs... I have and love them. Fitment is great, sound is even better!

Im debating on them HFCs.. good price.

I'll take the rear fog light.

PM Replied.

Exhaust sold!

Bump. HFC's, Injen Intake and OEM springs are still available.

Wednesday Bump. HFC's, Injen Intake and OEM springs are still available.

Lowest price?
 

HFC to 75201

pm sent

Prices dropped on remaining items. New prices are firm. Parts will go to ebay this weekend if not sold here.

Friday bump. Going to ebay tonight or tomorrow with the same starting prices. Get them now before bidding has an opportunity to drive prices up.

Where can I buy all the hardware for the HFC? I might take it if there's no problem getting all those replacement parts

All you need is 10 nuts and bolts and gaskets if you want to replace them. I believe you can buy a sheet of gasket material from any autoparts store or here: Amazon.com: Mr. Gasket 5960 Ultra Seal Exhaust Gasket: Automotive

You should be able to cut more gaskets than you need from a single sheet. You could reuse your existing ones but they might not seal as well.

HFC's Sold.

CAI and Springs now on Ebay. All other parts are sold.