Akebono's are here... Should be in Sat... I am ecstatic...
http://img.tapatalk.com/d/13/02/13/bepe6utu.jpg

Nice. I'm excited my Wife is getting her car back from the body shop. She backed it into a pole...

http://img.tapatalk.com/d/13/02/13/zemagety.jpg

This is what happens when you have 24 hour duty...

What??? Did them yourself?

Yes and a buddy of mine... I followed the sticky..for the most part.... Used 400 grit sand paper to rough em up a little bit, then just two good coats of caliper blue, didn't want them to get too dark..waited about 2 hours... Then put the stickers on and two coats of clear engine enamel...have them pre-curing under a spot light for a few hours then will stick them in the oven for a bit...
Not bad for under 50$... Have to see how they hold up... If I had F-ed it up too bad... They were going to get sent to get powdercoated, but I definitely wanted to try and do them myself... I am also going to try and install them...
http://img.tapatalk.com/d/13/02/13/nemy7ene.jpg

My 2DSC and 4DSC

Nice... Had some extra paint left over...
http://img.tapatalk.com/d/13/02/15/umasu2az.jpg

http://img.tapatalk.com/d/13/02/19/emymy2ab.jpg
http://img.tapatalk.com/d/13/02/19/ahadyvuv.jpg

2 down 2 to go... Weather got bad...

Got all the Akebono's installed...
http://img.tapatalk.com/d/13/02/25/tydesy2e.jpg
http://img.tapatalk.com/d/13/02/25/ava6useh.jpg
http://img.tapatalk.com/d/13/02/25/etepa5ut.jpg

Thought the CV1 would clear... But had to get a 5/16" spacer

Impressive. What was needed outside of what's on the car and what comes with the Akebono's?

Thanks Fire... Nothing really except the spacers...direct bolt on.. The 350z require a bracket...

Just finished waxing car... Smoking a black n mild jazz...http://img.tapatalk.com/d/13/02/27/8azamu4y.jpg

Love the akebono's...
Got a z1 Motorsport satin badge too..
http://img.tapatalk.com/d/13/02/27/5ehegabu.jpg

http://img.tapatalk.com/d/13/03/24/abe4yrag.jpg
Taillights smoked...
http://img.tapatalk.com/d/13/03/24/uny3asas.jpg
Custom floor fabricated for full size spare...
http://img.tapatalk.com/d/13/03/24/pytesyde.jpg
007 and 3/8ths custom started...http://img.tapatalk.com/d/13/03/24/4ybebujy.jpg
http://img.tapatalk.com/d/13/03/24/vume3ydu.jpg
Fabricating space for AR 15 next...

Also I ended up having to need spacers with my akebono and my Vossens..I bought a 7/16th inch (7mm) spacer for the time being but ordered a 10mm spacer from Z1, I also have the extended studs. I was wondering can I use the 10mm with my existing studs or do I need to replace them?

^^^^^ this fücking guy, LOL
SUCH A REDNECK, I love it!


You need extended studs to be safe brother!

Lmao... Thanks... She is the epitome of the Z into a Maxima baby commercial...