Haven't taken it out for a spin yet. I wanted to check in and make sure the air issue was normal.

I did it with the help of a friend. He did most of the disassembling, I fitted the tubes, we both reassembled.

I should be a hand model! Lol

Check my :ninja3:

Make sure your airbox is seated properly. There's a rubber/foam gasket in the front there where the inlet is that feeds air to the airbox. I had to readjust mine so the gasket had a good seal going to the front of the airbox.

It's too dark out now. I'll have to see if he can help me again. I didn't disconnect the sensors but was able to pull up the boxes and move around a bit, could have sworn we had that side lined up though.

What happens if i don't fix it?

Just tossed on my 20mm powertrix spacers in the front to even out with 25mm in the back.

Sent from my SAMSUNG-SGH-I777 using Tapatalk 2

Looks great Tibal. :)

Is that stock ride height?

:iagree:

Thank you very much! :D

I'm dropped on H+Rs. The angle and zoom is altering the image a bit I noticed. If you look at my sig pic you can see it more clearly.

Sent from my SAMSUNG-SGH-I777 using Tapatalk 2

If there's a way to get more air flow, then it's worth your while to fix it. It's not going to hurt anything though until you do.

:( I really am not looking forward to removing that thing again. Blah!

new mods for today
 

put in my lower rear control arm with a -3 camber re painted my strut bar and engine cover bought new tires and mounted them on got 2 hotchkis sway bars and installed it, bought new cold air intakes by AEM because i got some off brand intakes and got pulled over and got a ticket for my intakes not having a carb sticker... ******* cop... bought the front camber arms now just waiting for intakes and front camber arm...

Wished I could of washed my Z today but alas, miami's weather did not agree with that. Will be cleaning/detailing her over the weekend.

:worthless:

I'm just sayin'!:tup:

Am I the only one doing this? Lol

:tup: