Question about Rhino Ramps

kenchan · 08-27-2011, 11:37 AM

here you go guarddad-

ramp with extension... the arrow points at the rubber shoe that's on the ramp to prevent slippage. you can tell it's slightly raised while without any load.

here's the bottom side of the rhino ramp. make sure you have this shoe when you buy...

here you can see where the 2 screws go on when i attach the extension to the ramp...
i put masking tape on the rhino ramp to make it easier for me to aim where the extension goes to screw it down.

back side of the extension...

side view...sorry about the shadow of the bush...but you get the idea.

ive used this exact setup for over 10yrs now. no issue.

my Z is stock height, no issue clearing the stock diffuser when i had it. my G is pretty low too, no issue. ive not had one car yet that could not clear.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Race Ramps 56" 2 piece ramps	Glokwork	Nissan 370Z General Discussions	16	07-08-2011 09:09 AM
DIY Ramps	zzdudaka	DIY Section (Do-It-Yourself)	0	04-18-2011 03:51 PM
Need Race Ramps service ramps and trailer ramps? Save hundreds with this combo deal.	Fred@ReverseLogic	Tools / Ramps	1	03-04-2011 07:13 AM
NEW from Race Ramps - Two-Piece, Two-Stage Incline Race Ramps	Fred@ReverseLogic	Tools / Ramps	2	02-03-2011 09:27 PM
Race Ramps Question	Zeester	Nissan 370Z General Discussions	27	07-12-2010 04:39 PM

08-27-2011, 11:37 AM	#15 (permalink)
kenchan A True Z Fanatic Join Date: Aug 2009 Location: N/A Posts: 76,801 Drives: N/A Rep Power: 141522	here you go guarddad- ramp with extension... the arrow points at the rubber shoe that's on the ramp to prevent slippage. you can tell it's slightly raised while without any load. here's the bottom side of the rhino ramp. make sure you have this shoe when you buy... here you can see where the 2 screws go on when i attach the extension to the ramp... i put masking tape on the rhino ramp to make it easier for me to aim where the extension goes to screw it down. back side of the extension... side view...sorry about the shadow of the bush...but you get the idea. ive used this exact setup for over 10yrs now. no issue. my Z is stock height, no issue clearing the stock diffuser when i had it. my G is pretty low too, no issue. ive not had one car yet that could not clear.