what jack is that? mine does 18 inch i think

Actually after checking 24" is the jack I was going to get:Low Profile Floor Jack - 2 Ton, Rapid Pump® Jack

Mine is smaller and goes to 20"

i have a harbor freight one, and a craftsman one. both do the job i guess.

ok off to get the impact back out!

I wish there was a couple more inches of space sometimes...I can't fit the breaker bar in there (22" breaker bar)

anyone think this is an exhaust leak? i just tightened everything up again and was under the car while it was running but i didnt see or smell any exhaust there.

That sounds like the "hiss" that HFC , TP and LTH make. You have any of those on your car. If you do, then it's normal

a general rule, hiss on deacceleration = normal, hissing, rattling, etc noises on acceleration need to be check out to make sure everything it tightened.

yeah i have ART pipes

Then it's normal :tup:

just the noise the vq makes, once you put aftermarket CBe and change out the cats you will have that. The more open the exhaust, the more noticeable the noise.

yeah im not a VQ noob, but never heard it on the 350 with TP's and CBE. its all good thanks for the answer!

it's not all vq, just ones with vvel i think

:driving: ga zoom!

That jack might actually be useful to me. Sick of driving up blocks

For the front I think you will still need to drive up something or first jack up the front using the side jack points. Another member here has the long low profile jack, still can't get it to the front lift point.

morning from sunny charlotte!