Newby looking for power mods for '10 370Z

Cristobal09 · 01-11-2012, 09:05 AM

Quote:

Originally Posted by b1adesofcha0s

Also the rear camber arms are not always necessary. I didn't need them when I dropped my Z on the swifts. My rear camber is at -2.3/-2.4.

I was at -2.6 for the rears, after the ichibas I had them adjust it back to -1.8. I think the stock specs are between -2.1 and -1.2 or something? I would figure at what you are at, youll burn through tires much quicker. But what do I know, ive only had my car for 1300 miles.

b1adesofcha0s · 01-11-2012, 09:07 AM

Quote:

Originally Posted by Cristobal09

I was at -2.6 for the rears, after the ichibas I had them adjust it back to -1.8. I think the stock specs are between -2.1 and -1.2 or something? I would figure at what you are at, youll burn through tires much quicker. But what do I know, ive only had my car for 1300 miles.

Mine is only a little bit off, nothing too bad.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Newby question	Old Crow	Exterior & Interior	3	01-30-2011 11:07 PM
Hello Newby Here	Old Crow	New Forum Member	7	01-26-2011 03:13 PM
Another Newby	Bama Z	Introduction	3	10-07-2009 09:33 AM
G'DAY from the newby down-under	Aussie-Z	New Forum Member	2	06-25-2009 05:46 PM
And yet another Newby from (WA)	Nikon FM	New Forum Member	6	01-11-2009 02:48 PM