LNATKFRNG

Pink Floyd - Your car looks great. I'd like to meet up with you sometime to see it in person. I've had mine for almost 4 years, and I'm just now starting to upgrade. Could use some good advice/tips. Let me know if you are interested! Thanks

Polished, waxed and installed z1 hood struts nice fit

Zex list 17F/30N as 75hp 21F/38N as 100hp This is apparently measured at flywheel the "75 shot" nets me 63hp calculated using torque Great to see all the interest and discussion...

Yes it is, and then they list dual TB setups.

Zex list 17F/30N as 75hp 21F/38N as 100hp This is apparently measured at flywheel the "75 shot" nets me 63hp calculated using torque Great to see all the interest and discussion...

So thought I would share my build, First the thing sounds great, butt dyno says it spins up a bit quicker, I can definitely tell it accelerating from stop: Total cost:$497.00 Cnt resonated test...

Badges n calipers

Wheels look nice, thought about that myself but ya beat me to it. That z cars Guy has some pretty sick rides from time to time

I agree put a few passes down with your setup even at 75 shot then when you bump up decide what to do on the rear end. Just my humble opinion. My stock tires are not enough to get "good straight line...

Today she got 5 fresh quarts, the redline oil seems to hold up well! Added a fuel pressure guage and refilled the bottle.

Installed oem nismo cloth seat covers, just the same as the base but i like the color and embroidered nismo thing and for $150 i couldnt stop myself

Installed oem nismo cloth seat covers, just the same as the base but i like the color and embroidered nismo thing and for $150 i couldnt stop myself

Nope you do want some distance from the tb's but too far and you increase the chance of your mixture "puddling". The zex recommendation was 6-10 inches from the tb I don't think I would go further...

Nope you do want some distance from the tb's but too far and you increase the chance of your mixture "puddling". The zex recommendation was 6-10 inches from the tb I don't think I would go further...

Mega- zex recommends 6-10 inches from the tb mine are on the bottom of the silicone tubes at about 8 inches I used the same type of pipe reducer to adapt them as most systems use but I used a nut...

I also bought my nmu from some other than the oem u can down load the instructions from their site I'm sure, as for the zex rpm window switch it was pretty easy just tapped the #1 coil, the WOT...