AnthonyD1978

Hey Anthony. Did you ever get that unit installed for the fuel starvation issue? I ordered it but it's still sitting in the box in my garage. Life has been extremely busy for me the past few years and I hardly even drove the Z at all. But I want to install it now. After dealing with the key fob issue. It happened to me today. Went out to start the car and nothing. After looking on the forum here, it looks like it's a very common problem. Haven't had a chance to read about it in detail yet. What a hassle. I had to tow it home and tomorrow probably tow it to the dealer...

I spotted this car a couple times around Anaheim in the past month. It now has a 2015 Nismo front bumper. Slammed but still looking clean.

This came in the other day :) It's a shame that it's hidden away in the gas tank. http://www.the370z.com/members/anthonyd1978-albums-my-2010-nismo-370z-picture88309-image.jpg

-_hVHCX8VYs vstmLa-tBjE

https://scontent.xx.fbcdn.net/hphotos-xtf1/v/t1.0-9/11846566_10204732650617392_1938819547496798302_n.jpg?oh=6b295abaa41ed434464759b08ed3f3a9&oe=5650BD71

http://www.the370z.com/members/anthonyd1978-albums-my-2010-nismo-370z-picture88309-image.jpg

Parts needed: Drill and bits - to drill the 1/4" hole for the nozzles. Bumper does NOT have to be removed. You just have to drill at an angle. Start with a smaller bit for the pilot holes and work...

I was thinking of putting ice in mine too. Also thinking of using a alcohol mix in the tank. It should evaporate faster and pull heat faster. Not sure about the fire hazard though....

Parts needed: Drill and bits - to drill the 1/4" hole for the nozzles. Bumper does NOT have to be removed. You just have to drill at an angle. Start with a smaller bit for the pilot holes and work...

I was thinking of putting ice in mine too. Also thinking of using a alcohol mix in the tank. It should evaporate faster and pull heat faster. Not sure about the fire hazard though....

+1 Would like to see the mounting points of the support bars.

Are videos showing up for you guys? They were for me yesterday, but today they are not from my laptop. Show up on my iPHone though... Updated OP with more info.

Parts needed: Drill and bits - to drill the 1/4" hole for the nozzles. Bumper does NOT have to be removed. You just have to drill at an angle. Start with a smaller bit for the pilot holes and work...

Parts needed: Drill and bits - to drill the 1/4" hole for the nozzles. Bumper does NOT have to be removed. You just have to drill at an angle. Start with a smaller bit for the pilot holes and work...

7/27 - I'm no longer using John as my tuner. Severe personality conflict. Read from bottom to top. Anthony 3:52 PM (0 minutes ago) to John Hey John,

7/27 - I'm no longer using John as my tuner. Severe personality conflict. Read from bottom to top. Anthony 3:52 PM (0 minutes ago) to John Hey John,

Have ProECU detect your vehicle. After it detects the vehicle you get the separate window with multiple options. One of the options says ECM Tools. Idle Learn is in there. Make sure the car is...