BTW - I know we had our differences on the new trends etc etc, but I was watching a special on 'cool factories' and they were talking about Lamborghini...

Your wing beta so far reminded me so much of the new SV wing that I must say, if you water jet those arms to have the least amount of metal on them and carbon everything else this might actually come off looking spectacular...see the image below?!? I think you can really go for that look and get away looking good at the same time!

http://www.fourtitude.com/news/uploa...cielago_sv.jpg

and it has my scoops ! :)

Im telling you guys. You must have vision. I guarantee you if I posted a photo of that Lamborghini wing without you being able to see it on a car everyone would scream rice. There are a lot of F&F type wings that do look terrible, but a wing that is constructed of high quality materials that is properly sized and mounted to a car looks really good in my opinion.

Now, onto other things. Here's what I have been dreaming up for SEMA as far as decals go to make it stand apart from any other 370Z thats there. Of course the wing will be different, this one is just a photoshopped APR wing off of my old 350Z...

http://i129.photobucket.com/albums/p...ma09side-1.jpg

And yes, I know its pretty much a rip of of Ken Block's Ghymkana 2.0 car as far as the base graphics go, but I have no imagination.

Not bad...I like it. However, I feel like you need a little more green somewhere. Maybe some sort of pin stripe...i dunno.

Needs more APC stickers :)

diggin the graphics!!... perhaps don't end them so abruptly at front of door... let them spill over or fade more quickly... on your name, maybe just white instead of going black/white/black

Also, you should put the green spade suite on your hood....like what's in you avatar.

Looks great! Only one suggestion... a little bit NST would be awesome :tup:

Challenge Stainless Steel Brake Lines went on without a hitch!

Front:
http://www.doubledownmotorsports.com/challengebl2.jpg

Rear:
http://www.doubledownmotorsports.com/challengebl1.jpg

GTSPEC Prototype Rear Tie Brace fits!

http://www.doubledownmotorsports.com/gtspecrtb1.jpg

http://www.doubledownmotorsports.com/gtspecrtb2.jpg

http://www.doubledownmotorsports.com/gtspecrtb3.jpg

^That the Berk exhaust that has surface rust already?

Thats the prototype version solely used for fitment and testing. Not made of stainless steel like the production versions. That one is made of of the cheap stuff. I have to wait for my production version like everyone else :(.

ahh, forgot you were still rolling with the prototype...

Damn, they're not out yet? Weren't they supposed to have been release in Sept, some time?