:hello:

I'm having a hard time getting motivated to clean up the garage so I can actually work in it :(

I did manage to recover all of the nuts from the aerocatch latch mounting plates. So I finally mounted both of the CF finish latches to replace the faded black ones that were already on the hood :tup:

I made a mess in mine from the carbon fiber splitter, fender vents, rear sub-frame bushing. Grinding, welding, drilling, cutting. I need to have it cleaned up and my Z on the ground before Lein gets here. :eek:

Document the fender vent install. I have mine to do here very shortly. :tup:

hey Pint. :hello:

Position carefully. I got mine up a little too high on the fender. I'm about 1 1/2" down from the top roll of the fender. Maybe should have been down about 2 1/2 ". Everything fits flush but the bottom curve of the vent. Have about 1/4"gap that I have to play with. And cut the outside edge of the temp plate. Even doing that. I still had to made the hole bigger to get the vent into the hole.

Do you have the temp plates?

yeah, I have the 3d printed templates. I was holding the template up the other day looking for a good position. I was about where you were, 1.5" from the top. Ill look into dropping it a bit.

:ugh:

:hello:

:hello:
:ugh::ugh:
Can’t Sleep :ugh2:

I typed this wrong. It should be the inside of the temp plate, on the outside of your mark. :tiphat:

Same here. Went to bed, but just kept rolling. Restless legs. Don't know what to do with them sometimes. :shakes head:

Drinking big glass of chocolate milk. :yum:

I went ahead & got up...pusky noticed that i was awake & wanted some attention :ugh2:
Got my coffee & paying some bills,,,while occasionally glancing over at the stack of Benjamin’s for this afternoon :rolleyes:

:yawn: