Nissan 370Z Forum

Nissan 370Z Forum (http://www.the370z.com/)
-   The Lounge (Off Topic) (http://www.the370z.com/lounge-off-topic/)
-   -   The New "What did you do with your Z today" (with off topic replies) XXXII (http://www.the370z.com/lounge-off-topic/130092-new-what-did-you-do-your-z-today-off-topic-replies-xxxii.html)

Leingod 04-28-2019 07:08 PM

Quote:

Originally Posted by jchammond (Post 3847529)
Cold smoke what :ugh2:

A rack of ribs when I don't want to screw with temps all day for my smoker. So cold smoke for 2 hrs followed by a sous vide bath for 8 hrs.

Spoiler 04-28-2019 07:44 PM

2 Attachment(s)
Not sure what the weather was where all you guys are at, but it was pretty dang nice at my house today. Took Mrs Spoiler out for a three hour boat ride and then we set out back to see the sunset...

madwi 04-28-2019 08:27 PM

Quote:

Originally Posted by Spoiler (Post 3847537)
Not sure what the weather was where all you guys are at, but it was pretty dang nice at my house today. Took Mrs Spoiler out for a three hour boat ride and then we set out back to see the sunset...

Dont get much better than that!

God-Speed 04-28-2019 09:07 PM

Great day here in Austin. Could not have asked for better weather. Went to a 8;45am Avengers this morning. One word AWSOME!!!:tup: This evening grilled steak and salmon for the Mrs and myself. Great Day!! :tup:

madwi 04-28-2019 09:22 PM

IT was much warmer here than I thought it was going to be. Worked out in the garage most of the day.

jchammond 04-28-2019 09:22 PM

Night fellas; plan to make the transaction this week on the Z,,,then clean/cover :ugh2:

Rusty 04-28-2019 09:56 PM

Quote:

Originally Posted by madwi (Post 3847545)
Dont get much better than that!

:iagree:

Rusty 04-28-2019 09:57 PM

Quote:

Originally Posted by madwi (Post 3847553)
IT was much warmer here than I thought it was going to be. Worked out in the garage most of the day.

It was in the low 50's and overcast today. Tomorrow in the mid 70's. :tup:

Rusty 04-28-2019 10:03 PM

Got the right side 3" brake hose done. :tup: Boy, that's a tight fit. Had to oval the hose for tire clearance right above the sway bar. Tomorrow, I will have the left side done.

Rusty 04-28-2019 10:04 PM

Snackin' on some pizza rolls. :yum:

Rusty 04-28-2019 10:09 PM

:werd:

Taylor Swifting

:tiphat:

eastwest2300 04-28-2019 10:15 PM

Quote:

Originally Posted by madwi (Post 3847520)
Ew earned his storage of the Z. Helped me move bandsaws and other heavy *** crap back downstairs. Made ribs in sous vide bath; 165f for 6 hours. They needed a bit more bath time I think. The turned out edible though.

we got a lot of work done, im full of painus...

Hotrodz 04-28-2019 10:17 PM

Quote:

Originally Posted by Rusty (Post 3847569)
Got the right side 3" brake hose done. :tup: Boy, that's a tight fit. Had to oval the hose for tire clearance right above the sway bar. Tomorrow, I will have the left side done.

Had to do the same stuff when I had the 3" hose upgrad done. They used the Stillen spindle and made better hose attachments. The driver's side had to be squished to avoid tire rubbing. The you shouldn't have any issues with the passenger side.

Sent from my SM-G965U using Tapatalk

eastwest2300 04-28-2019 10:18 PM

good night itches...

Spooler 04-28-2019 10:27 PM

Quote:

Originally Posted by Rusty (Post 3847569)
Got the right side 3" brake hose done. :tup: Boy, that's a tight fit. Had to oval the hose for tire clearance right above the sway bar. Tomorrow, I will have the left side done.

Sounds like I am done for when I do my brake duct install. Ugg, not good.

Rusty 04-28-2019 10:29 PM

Quote:

Originally Posted by Hotrodz (Post 3847576)
Had to do the same stuff when I had the 3" hose upgrad done. They used the Stillen spindle and made better hose attachments. The driver's side had to be squished to avoid tire rubbing. The you shouldn't have any issues with the passenger side.

Sent from my SM-G965U using Tapatalk

I had to oval the hose on both sides for tire clearance. In the same spot. The driver side is almost a straight shot from the inlet to the coilover. The passenger side was a little harder. Had to go around the washer reservoir. The splitter makes to easier to route the hose because it sits a little lower then the wings on Zspeed under tray.

Rusty 04-28-2019 10:44 PM

Quote:

Originally Posted by Spooler (Post 3847582)
Sounds like I am done for when I do my brake duct install. Ugg, not good.

If you can make a low profile 90deg elbow at the ducts. Have them turned to the outside. Then the hose. Think you could be fine. You will need about 7ft per side. I used little over 5ft per side. The orange hose is stiffer then the black, but has a higher temp rating.

jwick 04-28-2019 11:07 PM

Quote:

Originally Posted by God-Speed (Post 3847549)
Great day here in Austin. Could not have asked for better weather. Went to a 8;45am Avengers this morning. One word AWSOME!!!:tup: This evening grilled steak and salmon for the Mrs and myself. Great Day!! :tup:


Avengers could of been 30-45 mins shorter.

jwick 04-28-2019 11:09 PM

So what the hell is this picture of an air box that looks like it has tater tots and smartie wrappers in it?

Spooler 04-28-2019 11:22 PM

Quote:

Originally Posted by jwick (Post 3847589)
So what the hell is this picture of an air box that looks like it has tater tots and smartie wrappers in it?

He had a little mice problem obviously. That is dog food. LOL That mouse loved dog food and smarties'. LMAO

jwick 04-28-2019 11:32 PM

Quote:

Originally Posted by Spooler (Post 3847591)
He had a little mice problem obviously. That is dog food. LOL That mouse loved dog food and smarties'. LMAO


Whose car?

madwi 04-28-2019 11:38 PM

Quote:

Originally Posted by jwick (Post 3847593)
Whose car?

TheWolfe I believe.

madwi 04-28-2019 11:45 PM

Quote:

Originally Posted by jwick (Post 3847588)
Avengers could of been 30-45 mins shorter.

Idk if I want to see it or not. I havent gotten into the movies too much.

Pintsize725 04-28-2019 11:47 PM

Quote:

Originally Posted by jwick (Post 3847588)
Avengers could of been 30-45 mins shorter.

I think you mean longer. :icon17:

I wasn't ready.....

jwick 04-28-2019 11:49 PM

Quote:

Originally Posted by madwi (Post 3847595)
Idk if I want to see it or not. I havent gotten into the movies too much.


The one with Ultron is still the best.

jwick 04-28-2019 11:51 PM

Quote:

Originally Posted by madwi (Post 3847594)
TheWolfe I believe.



You sending ‘TheWolfe’?

Oh, that makes you feel better?

madwi 04-28-2019 11:56 PM

Quote:

Originally Posted by jwick (Post 3847598)
You sending ‘TheWolfe’?

Oh, that makes you feel better?

pulp fiction?

TheWolfe 04-29-2019 12:58 AM

Quote:

Originally Posted by jwick (Post 3847589)
So what the hell is this picture of an air box that looks like it has tater tots and smartie wrappers in it?

:hello:

Rusty 04-29-2019 02:30 AM

Don't trust a fart. :tiphat:

jchammond 04-29-2019 03:03 AM

:ugh:

jchammond 04-29-2019 03:04 AM

Quote:

Originally Posted by Rusty (Post 3847608)
Don't trust a fart. :tiphat:

Depends on what I’ve had to eat :wtf2:

JARblue 04-29-2019 03:09 AM

Everyone have a wonderful Monday :hello:

Spoiler 04-29-2019 03:43 AM

Morning gents...

Spoiler 04-29-2019 03:45 AM

Today, I am painting the inside of my garage... got about a third done yesterday. I should finish today...

Spoiler 04-29-2019 04:54 AM

And it is currently, T-6 at the Bacon launchpad... :yum:

Spoiler 04-29-2019 04:55 AM

T-5

Spoiler 04-29-2019 04:56 AM

T-4

Spoiler 04-29-2019 04:57 AM

T-3

Spoiler 04-29-2019 04:58 AM

T-2

Spoiler 04-29-2019 04:59 AM

T-1 ... Ignition systems on....


All times are GMT -5. The time now is 10:11 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2