:rofl2::rofl2::rofl2::rofl2::icon18:

:icon18:

Some hell!! I'm fighting with this clutch helper spring. Took forever to get the pin out. Then I struggled getting the assembly back in. Nos I can't even get close to pushing the pin back in. What am I doing wrong?

Do you have sufficient lighting? im right handed and held the flashlight in my left hand like a dagger while supporting my body with my elbow. this freed up my right hand.

i read people crying about how difficult it was to install, but it wasn't difficult for me :confused:

I can't get the bolt back in at all. And I can't lift the assembly at all.

I can find the holes for everything. Freaking bolt just isn't going in at all.

you tried giggling it around, right? it needs to be aligned perfectly for the shaft to go back in. use a small hammer and tap the bracket. (dont hammer it in btw)

Yea. I also marres it a little just getting it out. Nothing crazy

I can't get it past the first hole on the assembly.

push the pedal in very slightly and it should slide right back in.

I just removed the whole assembly. I can't get the bolt in at all. It's way to right. I'd have to hit it with a hammer

Touch the marred up spot with a bit of sandpaper, just enough to knock the high spot down.