|
Loosen up all of the bolts and jack up on center section with floor jack. Start tightening from the cats back to the rear, that should fix your crossmember problem.
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
11-11-2012, 08:48 AM
|
#2 (permalink) |
|
Enthusiast Member
 
Join Date: Feb 2011
Location: Pensacola FL
Posts: 268
Drives: '10 370Z
Rep Power: 19   |
Loosen up all of the bolts and jack up on center section with floor jack. Start tightening from the cats back to the rear, that should fix your crossmember problem. The passenger side piping does hang a little lower but you can rotate your canister then tighten up the rear sections at the flange to even them out.
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SPC install help | Carbon_z | Brakes & Suspension | 14 | 05-31-2012 08:53 AM |
| HID install went bad :/ | 370zmarc | Exterior & Interior | 0 | 03-07-2012 01:38 AM |
| Install my own GTM kit? | MattP725 | Forced Induction | 31 | 10-17-2011 08:17 AM |
| CBE install first, then HFC, or together? | TruKoi | Intake/Exhaust | 2 | 06-15-2011 10:49 PM |
| can anyone install my hfc | thegraylady | Intake/Exhaust | 6 | 04-16-2010 10:46 AM |
1Likes
Threaded Mode
