No doubt....A friend of mine who owns the local Rice shop has a very tricked out 350. He just put this stuff on his (larger) oil pan and rear Dif, figuring it could not hurt. I don't think he's actually measured any reduction (no cooler but he is instrumented) but he feels better about it anyway! Get heat dissipation any way you can.

"Cooling brings Ecology Life" Hmm . . . okie doke. :ugh2:

I would have to say that that is a poor traslation. :shakes head:

Today's update: Unfortunately the 2.5" ID (+ 14% surface area) kept trending downward (Lean) and started to feel a little flat. Just a tad too big on the ID. I sleeved the MAF tubes today to bring them down to 2.42" (+ 6% surface areas) and things felt a lot snappier. As you can see, 1/10th of an inch makes a big difference here. Long term fuel trims seem to be trending back toward Zero. I'll run it this way for awhile and see where it goes. I have another sleeve available to take it to 2.37 if I need a little more....

Fresh air feeds from the Fang area now up in the DIY section:

http://www.the370z.com/diy-section-d...ur-airbox.html

http://images50.fotki.com/v1514/phot...MG_1896-vi.jpg