Just installed K&N Typhoon intake...problem...

JrumMusic · 04-16-2011, 12:18 PM

The intake is amazing, sounds great...but for some reason now, my driver side window wont roll up when the door is open, and when i get out and close the door, usually the window will be down a bit and roll up, now its opposite, everytime i close my door the window goes by a inch or 2 every time i close door, until it completely down. -____- FML.

Any suggestions? Im guessing it has to do with taking the negative battery terminal off before the install. Ugh...

KillerBee370 · 04-16-2011, 12:41 PM

You gotta reset the windows homie

KillerBee370 · 04-16-2011, 12:43 PM

I don't remember the way to do it exactly. I think you get in and turn the car on (not ignition) and hold the window buttons down (windows go down) for like a minimum of 10 seconds and then roll them all the way up. Turn the car off. Should be fixed.

I think... there's a thead on this somewhere

JrumMusic · 04-16-2011, 12:52 PM

Quote:

Originally Posted by KillerBee370

I don't remember the way to do it exactly. I think you get in and turn the car on (not ignition) and hold the window buttons down (windows go down) for like a minimum of 10 seconds and then roll them all the way up. Turn the car off. Should be fixed.

I think... there's a thead on this somewhere

Thank you so much for responding so quick im trying to find the thread as i type.

wilsonp · 04-16-2011, 01:03 PM

Actually in manual page 2-41 but here is a post:
how do i reset my car??

JrumMusic · 04-16-2011, 01:05 PM

I fixed it i found a thread that says this.... IM SO HAPPY NOW!! THANKS GUYS!! I LOVE THIS ******* SITE!!

Have the car turned off.
Press the ignition twice to get into ON mode, but don't depress the clutch (Don't start the car)
Using the window switch, fully lower each window and then fully raise it back up **HOLD FOR 5 SECONDS IN UP POSITION**
Push ignition once to turn off the ignition.
Start car normally, windows should be reprogrammed.

KillerBee370 · 04-18-2011, 09:44 PM

Quote:

Originally Posted by JrumMusic

I fixed it i found a thread that says this.... IM SO HAPPY NOW!! THANKS GUYS!! I LOVE THIS ******* SITE!!

Have the car turned off.
Press the ignition twice to get into ON mode, but don't depress the clutch (Don't start the car)
Using the window switch, fully lower each window and then fully raise it back up **HOLD FOR 5 SECONDS IN UP POSITION**
Push ignition once to turn off the ignition.
Start car normally, windows should be reprogrammed.

I knew it was something like that.

Zoren 370 · 04-08-2012, 06:19 PM

Would there be any problem if you do not disconnect the negative terminal while installing the K&N CAI?

370ZilverZ · 04-08-2012, 06:25 PM

Quote:

Originally Posted by Zoren 370

Would there be any problem if you do not disconnect the negative terminal while installing the K&N CAI?

I installed my Typhoons and did not disconnect the battery without any issues.

USMCASA · 04-08-2012, 06:27 PM

Quote:

Originally Posted by 370ZilverZ

I installed my Typhoons and did not disconnect the battery without any issues.

+1 when all else fails follow instructions

Zoren 370 · 04-08-2012, 06:39 PM

Thanks for the quick response? How about the ECU? do i need to have it reprogrammed?
Can you share some of your reviews with this intake? I read with others reviews there was a lost of torque below 3K rpm compared with previous closed box. Did you have the same problem?

370ZilverZ · 04-08-2012, 06:40 PM

Are you planning on exhaust mods in the near future?

USMCASA · 04-08-2012, 06:47 PM

Quote:

Originally Posted by Zoren 370

Thanks for the quick response? How about the ECU? do i need to have it reprogrammed?
Can you share some of your reviews with this intake? I read with others reviews there was a lost of torque below 3K rpm compared with previous closed box. Did you have the same problem?

don't need the ecu reprogrammed. i noticed a huge gain up top along with a much more throaty sound under wot. low end loss was not noticed at all and my miles per tank has gone up about 20-30 mpt. downside is that unless i baby it and don't make it make noise my overall gas mileage has gone down due to the added fun with the increase in power and sound. i love mine.

Zoren 370 · 04-08-2012, 06:50 PM

Quote:

Originally Posted by 370ZilverZ

Are you planning on exhaust mods in the near future?

maybe not in the near future... I'll try to start play around with the intakes first. R u planning to part out your exhaust?

370ZilverZ · 04-08-2012, 06:50 PM

Quote:

Originally Posted by USMCASA

don't need the ecu reprogrammed. i noticed a huge gain up top along with a much more throaty sound under wot. low end loss was not noticed at all and my miles per tank has gone up about 20-30 mpt. downside is that unless i baby it and don't make it make noise my overall gas mileage has gone down due to the added fun with the increase in power and sound. i love mine.

I would just enjoy them as they are and if you upgrade your cats and exhaust, go the next level with an UpRev tune to be sure you unleash all you can out of your mods.

04-16-2011, 12:18 PM	#1 (permalink)
JrumMusic Enthusiast Member Join Date: Mar 2011 Location: Florida Posts: 324 Drives: Pearl White 370z Rep Power: 14	Just installed K&N Typhoon intake...problem... The intake is amazing, sounds great...but for some reason now, my driver side window wont roll up when the door is open, and when i get out and close the door, usually the window will be down a bit and roll up, now its opposite, everytime i close my door the window goes by a inch or 2 every time i close door, until it completely down. -____- FML. Any suggestions? Im guessing it has to do with taking the negative battery terminal off before the install. Ugh... __________________ Pearl White 370z \| Sport Package \| 19" Rays \| Stillen Oil Cooler \|Ark CBE \| K&N Short Ram Intake \| Kenwood 7" Nav Unit \| Custom Sound System \| More mods coming soon

04-16-2011, 01:03 PM	#5 (permalink)
wilsonp A True Z Fanatic Join Date: Jul 2010 Location: Virginia Posts: 1,134 Drives: 2009 Touring Sp Nav Rep Power: 16	Actually in manual page 2-41 but here is a post: how do i reset my car?? __________________ 2014 Cayman S PDK Sport Chrono White/Black Was 2009 370Z Touring Sport+Nav 7AT Metallic Black/Persimmon Was 1991 NSX Auto Black/Black

04-16-2011, 01:05 PM	#6 (permalink)
JrumMusic Enthusiast Member Join Date: Mar 2011 Location: Florida Posts: 324 Drives: Pearl White 370z Rep Power: 14	I fixed it i found a thread that says this.... IM SO HAPPY NOW!! THANKS GUYS!! I LOVE THIS ***** SITE!! Have the car turned off. Press the ignition twice to get into ON mode, but don't depress the clutch (Don't start the car) Using the window switch, fully lower each window and then fully raise it back up HOLD FOR 5 SECONDS IN UP POSITION Push ignition once to turn off the ignition. Start car normally, windows should be reprogrammed. __________________ Pearl White 370z \| Sport Package \| 19" Rays \| Stillen Oil Cooler \|Ark CBE \| K&N Short Ram Intake \| Kenwood 7" Nav Unit \| Custom Sound System \| More mods coming soon**

04-08-2012, 06:40 PM	#12 (permalink)
370ZilverZ A True Z Fanatic Join Date: Dec 2011 Location: DFW, TX Age: 66 Posts: 2,321 Drives: '11 BMW Z4 Rep Power: 18	Are you planning on exhaust mods in the near future? __________________ 370ZilverZ Journal BMW Z4

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
K&N Typhoon Install problem	VaGntlmn	Intake/Exhaust	55	06-26-2012 04:23 PM
IL: K&N Typhoon 69 Series Intake (370z/g37)	ohno	Parts for sale (Private Classifieds)	11	05-22-2011 03:02 PM
K&N Typhoon Intake & other mods	fmusignac	Intake/Exhaust	7	03-12-2011 09:49 AM
F/S: k&n typhoon intake kit.	henry0844	Parts for sale (Private Classifieds)	8	01-31-2011 04:57 AM
WTB: K&N Typhoon Intake	omgZ	Wanted	0	01-18-2011 02:08 AM

04-16-2011, 12:41 PM	#2 (permalink)
KillerBee370 A True Z Fanatic Join Date: Mar 2009 Location: So Cal baby! Age: 51 Posts: 5,964 Drives: with passion Rep Power: 321	You gotta reset the windows homie

04-16-2011, 12:43 PM	#3 (permalink)
KillerBee370 A True Z Fanatic Join Date: Mar 2009 Location: So Cal baby! Age: 51 Posts: 5,964 Drives: with passion Rep Power: 321	I don't remember the way to do it exactly. I think you get in and turn the car on (not ignition) and hold the window buttons down (windows go down) for like a minimum of 10 seconds and then roll them all the way up. Turn the car off. Should be fixed. I think... there's a thead on this somewhere

04-08-2012, 06:19 PM	#8 (permalink)
Zoren 370 A True Z Fanatic Join Date: Mar 2012 Location: FL Posts: 11,018 Drives: 11 Nissan 370 M6 Rep Power: 1913653	Would there be any problem if you do not disconnect the negative terminal while installing the K&N CAI?

04-08-2012, 06:39 PM	#11 (permalink)
Zoren 370 A True Z Fanatic Join Date: Mar 2012 Location: FL Posts: 11,018 Drives: 11 Nissan 370 M6 Rep Power: 1913653	Thanks for the quick response? How about the ECU? do i need to have it reprogrammed? Can you share some of your reviews with this intake? I read with others reviews there was a lost of torque below 3K rpm compared with previous closed box. Did you have the same problem?