|
I loosened up the exhaust hangers, the joint where the y-pipe meets the exhaust and the joint where the mufflers bolt to the exhaust section and jiggled it around until
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
11-21-2010, 12:26 PM
|
#7 (permalink) |
|
Track Member
Join Date: Aug 2010
Location: Austin, TX
Posts: 637
Drives: 10 370Z T/S M6
Rep Power: 16  |
I loosened up the exhaust hangers, the joint where the y-pipe meets the exhaust and the joint where the mufflers bolt to the exhaust section and jiggled it around until it looked good. I thought for sure as soon as i tightened things back up it would be back in the same spot, but low and behold the **** didn't move. Looks good now! Except the passnger side tip is a little off center.
__________________
Berk HFC & CBE, Stillen G3's, AMS Crank Pulley, JWT Flywheel, 4.08 Gears, UpRev, H&R Springs and 20mm Spacers, JDM Rear Fog, EVO-R Front Lip and CF Upper Cover, 305's |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cleaning my F.I. exhaust tips? | Reaper42 | Intake/Exhaust | 20 | 04-16-2012 10:32 AM |
| Polishing exhaust tips | NeverBoneStck | Intake/Exhaust | 3 | 10-23-2010 12:41 AM |
| Adjusting FI exhaust tips | tjlazer | Intake/Exhaust | 7 | 10-16-2010 09:37 PM |
| uneven exhaust tips | darthanakin23 | Intake/Exhaust | 0 | 07-24-2010 05:54 PM |
| Oil residue on exhaust tips... | DIGItonium | Engine & Drivetrain | 12 | 06-05-2009 12:30 AM |
Threaded Mode
